SEMP TV Repair: Common Faults and Solutions.
Search: SEMP
Results: 2828
Results: 2828
SEMP Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| SEMP TOSHIBA | TV1480 | The television had no image and no sound, the horizontal stage did not oscillate, the 9 volts on pin 21 of IC 501 were cut off. The power supply was normal, it turned on and off normally. | Shorted deflector coil. I replaced the deflector coil, and the TV worked. | Eletrônica LM | |
| SEMP TOSHIBA | TV 2121 NFS U 18 | It turned on the standbay and turned it off until it reached m+ b | Swap str 5453 roco sound q 906 | ELETRONICA IDEAL | |
| SEMP | TV 1470E | Reduced frame,+b low | C818 22mfx50v | Manoel | |
| SEMP TOSHIBA | TV2070E | Image closing the sides and folding | T803 open | Roque | |
| SEMP | TS207/167/207 E TVC140 | Replace | Burnt 20Ω r613 | Replace | Tectoy |
| SEMP | TS207VS | Flyback buzzing and jagged image | 408 capacitor of 10 micros for 16v ruim | Replace | Tectoy |
| SEMP | 2070 E 1470 | Reduced vertical at the bottom | Capacitor 317 spacious | Replace | Tectoy |
| SEMP | 2070 E 1470 | It doesn't arm and tsound is a lack of 9v on IC 501 and a short between the base and q813 emitter | 826 open resistor | Replace | Tectoy |
| SEMP | 2070 E 1470 | +b changed to 149v and high voltage changed on the flyback pacifier with strong humming at the power supply | Capacitors 818 and 830 dry | Replace them | Tectoy |
| SEMP | 2070 E 1470 | Screen does not light up, 180 voltage changes depending on image clarity | Open 12k r321 | Replace for another | Tectoy |
| SEMP | 2070 E 1470 | Low power supply at 70v | Q811 short | Replace for another | Tectoy |
| SEMP | 2070 E 1470 | Heating r417 | Shorted deflector | Replace for another | Luiz Tectoy |
| SEMP | 2070 E 1470 | TV stuck on channel 30 | Change l651 (intermediate frequency output detector) | Luiz Tectoy | |
| SEMP | TV 2122 | Vertical closed | D885 | fabiusmax | |
| SEMP TOHIBA | TV2080EAV | Entering the menu alone also lowers the volume | Ca.78 shorted | julio itaguai | |
| SEMP | TV1490IAV U14R | Blue screen and no sound | Q612 shorted close to cable m501a | Replacement | PAULO-MACEIO/AL |
| SEMP | TV 1490 U 14 | Disarms when turned on, +b above normal | Fly back with slight short | Just keep changing | Manoel |
| SEMP TOSHIBA | TV-2087 U11 | TV is stopped and doesn't turn on | Changed smd resistor almost open | Just replace r 887 1k with the replaced value | João Carlos |
| TV SEMP | 2080E G74/287J | Does not turn on... controls on the panel do not work | Open power supply fuse zp01 | When this TV arrived it didn't work, then I found this power supply fuse open, after changing the ic801, reg 7805 it got very hot although it worked but the panel controls didn't work, I found a zener near the 6.2 volt micro or the da96 in short, after the replace tsound was zero bullet. | Alex - 3AT210 |
| SEMP | TV 2084 U10 | Image to the right 1 cm and does not follow the hpos adjustment | Eeprom 24c04 | ÁdrianChapadãodoCéu |