Samsung TV Repair: Common Faults and Solutions.
Search: Samsung
Results: 3759
Results: 3759
Samsung Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| SAMSUNG | CN3383V | Does not tune to loud channels, only makes scratches on the screen on loud channels. | R of 3r3 with changed value inside the selector on pin bp(5v) feeds internal ci of the selector. | Bruske | |
| SAMSUNG | LN32A330 | Saturated image | Replace ic 6002 - lm358d | GEORGE | |
| SAMSUNG | CB-20F12T KS1A | Image goes back and forth after adjustment in tl | Change capacitor in c802 power supply | alacyte | |
| SAMSUNG | CL21Z43MQ | It only works if it says it fits, the tube plate looked like it was the tube but it wasn't | It was broken tracks at the foot of the flyback | Splice or weld splinters | Eletroclaudio Aguas Belas PE |
| SAMSUNG | CL29Z58MQ | Dead | Simple flyback | Taking the output, I verified that all voltages appeared, in the +b of the flayback the voltage is 130 v. It was 165. This is normal because the flayback was bad, when I replaced it the voltage went to 130v. it cost!!! | XANDEDANTAS |
| SAMSUNG | CL29A551GQ | Turns on std by blinks and doesn't turn on | L lr404s auterated diode with leakage transistor qw402 shorted | I found the leaking diode, diode 404, I replaced it and the TV started to work but with a faulty pad, I replaced the qw402 transistor, I could put an IRF 630, but the ATV continued to have the defect, the aumofada, so after examining the components, I found the lr404s a little toast, so I replaced it with a Another one is 3.0mh, I put a 1.0mh one in and the TV started working again, defect brabinho oxente if god and for us who will be against us. let's help everyone. | fernando timbauba PE |
| SAMSUNG | CN5083 5083VB | Excess brightness with horizontal lines. | R409 changed vertical feed. | João SF. | |
| SAMSUNG | CL2921MQ | Inoperative - stand by lights up once and goes out | Defective center beam | ||
| SAMSUNG | CL-21M6MQ | This TV had all the voltages and it seemed like it would work but it didn't work and it made a horizontal noise. | The defect was the shorted deflector. | Replace | Eletroclaudio Aguas Belas PE |
| TV SAMSUNG | CL-21Z50MQ * | Due to frequent power outages, nothing works | Ic-801s cq0765rt com avaria | Your replace. | wagner |
| SAMSUNG | LN32B350F1 | Sem image | Inverte board transistors | fabricio | |
| SAMSUNG | CL-21Z50MQ | Bluish color varying flashing color | Diodo zener | Replace diodo zener 244 5.6v | fernandoferreira |
| SAMSUNG | CN-5051Z_5055Z_3355 - P62SN | Does not turn on, power supply with normal voltages and LED on | Change horizontal drive transformer' | Open horizontal drive transformer | johnny busnadiego |
| SAMSUNG | CN 3355Z P62SM | Dark band at the bottom of the screen, returning to normal when heated | 2.2uf x 50v capacitor, like low capacitance | Replace with another of the same value. | ELETRONICA HEINZ |
| SAMSUNG LCD | LN32A330 | Image saturating, like a sublimated cathode on a tube TV. | Power supply ok, video card ok digital card damaged. | Replace, the same board cannot be repaired. | CALIXSERVICE |
| SAMSUNG | CX-5344N SCT11 | Starts with difficulty | Replace the c220mf400v in the primary power supply | Matola | |
| SAMSUNG | CL-21Z50MQ K16C | Does not turn on the dead secondary power supply | Open non-primary resistor r802 | Check they all work in series 22k the r802, r803 and r804 | THIAGO SAMPAIO |
| MINITOR SAMSUNG | LIBRA 15/17 OU SYNC MASTER 769V 11-1 LE 15/17 | Monitor turns on and LED flashes when the PC is disconnected | Ic 622 e berto | Replace the same | lebarderio |
| SAMSUNG-LCD | LN19R81B | Has sound but no image | Tiny fuse blown at the power supply | VILMA CLÉCIA CARVALHO | |
| SAMSUNG | LN40A450 | Does not work or takes time to turn on | The two 1000 micron capacitors of the power supply | MB Eletronica |