Sony TV Repair: Common Faults and Solutions.
Search: Sony
Results: 20067
Results: 20067
Sony Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| SONY | KDL32R434A | Freezing image. | Freezing image. remove r835 , r836. r827. r828 . close to u802 . u801 | To remove . resistors r835. 836. 827. 828 . close to u801 and u802 | Nando tech tv |
| SONY | KDL 46NX705 | Turns on, appears very weak and turns off, flashes 6x | Open smd fuse ps6800. replace burns again. Check the LEDs, tsound will be an open bar or an earthquake causing the mass to burn only Q6814 as well. | Techmix eletronica | |
| SONY | LBT-N555AV | Turns on after a while, freezes and turns off completely | Replace ic702 do reset | BARBADINHA | |
| SONY | ADP-200ER | 4.8v from stanby and 4.7v from detect ok, but when you activate the power supply all voltages disappear | One of the returns is missing in the primary power supply | Replace ic32 (dda001ag) | Deo Eletrônica 8198904-0186 |
| SONY | KDL-40BX425 | Red standby, it goes to green and doesn't come out of it, it stays stuck, it doesn't turn on or off. ci hdmi ok, regulators with normal voltages | Customer reported a power surge that corrupted flash memory files. | Update the pkg software, sony_fw_2011_bz_tarte_1.14.pkg (found on 4shared) | World TV - Sorocaba |
| SONY | HCD-ZUX9 | Works normally, just no sound comes out on the CD and USB | Ci on the main board | Replace ci ic500 code hc4052 audio switcher. problem solved | carlos jc eletronica |
| SONY | KDL-48R550C | When turned on, the logo appears but without an image. sound and backlight working normally. | Upgrade/update firmware | Andreas | |
| SONY | KDL 48R555 | Does not turn on, red LED flashes 5 times | Short on hdmi input, capacitor close to c.i | Eletrônica Moisés N.H | |
| SONY | KDL-40W605B | The TV came to me when it turned on and after inserting the antenna and generating an image a few seconds later it turned off and the red LED flashed 6 times (LED bus error), however after this problem was resolved it maintained the symptom, but it took a little longer to turn off . | Regarding the bus error, the solution is to replace the bars, regarding the fact that the same symptom persists, I discovered that pin 31 of the ic-bd9397efv is the pin that sends information to the CPU about malfunctions in the backlight, but it only does this after some time (until the capacitor is charged) and the solution is to add a resistor in parallel with the capacitor which makes it impossible to charge so that the fault data is not sent to the cpu. | This email address is being protected from spambots. You need JavaScript enabled to view it. São Luís -MA Contato Whatsapp 98 982677363 | |
| SONY | KDL46NX705 | Led flashing 6x bad and weak backlight with 278v | Burnt out led bars | Arm the aps262 (ch) power supply in isolation with the 3v stby with 47r resistors for power on, bl on, dimmer and dc dimmer replaced components ps6800 0.5a q6814 2sk4096 r6853 100r ic6802 jrc2904 r6850 increase the value to decrease the led current | Gero Som |
| SONY | KDL46NX705 APS262 (CH) | LED flashing 6x | Burnt out led bars | Arm power supply in isolation stby 3v with 100r resistors for, power on, bl on, dimmer and dime | Gero Som |
| SONY | XBR-46HX925 | Turning off after approximately 30 seconds | Tsound was a short in the flat cable that connects the LED board to the inverter board | I removed the short in the flat with the help of a razor, short caused by the nut that goes to the wall bracket screw | Marcelo |
| SONY | ADP-160ER AAA | Sem os h.shtv to acin-det | Without power from ic43 (photo coupler) | Replace regulator ic31 (t4r) | Deo Eletrônica (81)98904-0186 |
| SONY | KDL-50W805 | Pisca led 3x | After checking all the capacitors of the converters I arrived at IC 9104 101104 which provides 1.5v DDR3 and 3.3V main 1 tsound was no open fuse and no shorted capacitor | techmix eletronica | |
| SONY | HCD-GTR888 | Protect, press play and stop simultaneously showing, power supply | C4041 is not shorted, but it kills the power supply to the 18v 7818 regulator. | EduSSantoz | |
| SONY | KDL-40R485A | Doesn't start | Pressing the power key, the standby LED turns off and turns red and the TV does not turn on | Def: power supply it uses several power supply models and replaces the circuit in my case it was the c122 47/35 | Marivaldo |
| SONY | KDL-40R485A | TV doesn't turn on or sometimes it turns on when pressing the power key, the standbay LED turns off and returns to red and the TV doesn't turn on | External power supply floating has been replaced | Marivaldo | |
| SONY | ADP-240AR AA | Normal standby and detect voltages, however when activating the power supply all voltages die | Ic 32 ( dda001ag ) | Deo Eletrônica (81)98904-0186 | |
| SONY | ADP-240AR AA | Burning high mosfets (q3 and q4) 13mn60n both, and opening f3 | Diode d81 leaking or short | Just in case, replace the two diodes d81 and d82 immediately and check the 15 homs resistors in parallel with them | Deo Eletrônica (81)98904-0186 |
| SONY | ADP-160ER AAC | Sem os h.shtv to acin-det | Ic43 (coupler photo) | Replace the same | Deo Eletrônica (81)98904-0186 |