Search: LG
Results: 4833

LG Repair Guide: Common Issues and Fixes

Brand Model Fault Detailed Problem Solution By
LG42PJ250
PB02A
Does not turn on, stand by inoperativeShort circuit on the +5_vst line, c 502 (10uf/10v)Replace c 502 (10μF/10v)leitemarcellus
LG21FX5RL-LD
Doesn't startQ 804 (bc -337)Replace the same.BARRETO CRUZ
LG21FX5RL-LD
Does not turn on, just stays on standbyCapacitor 835 (100uf/160v)Replace the same.BARRETO CRUZ
LG21FU1RL
Oscillates and disarmsIf you increase the screen and keep pressing ch+ you will notice that retrace lines will appearCause was the c308 replace without measuring
LG42PQ30R
Hits the relay directly and does not armDiode d352 (sb3200) in the main power supply and in the side power supply 100/50v capacitor c519 change without measuring as it seems to be goodELETRONICA AUTO TREVO
LG21FU4RL
Horizontal fora fequenciaR 512 next to ci 501 changes to just over 23kR 512 22kmecinhor7
LG21FX5RL
Doesn't workFotoacoplador c 810 (22/50v)This email address is being protected from spambots. You need JavaScript enabled to view it. (Bruno)
LG21FJ8RL
Does not tune channels without 33 voltsR-114-30kSwap -openLUCIANO
LGCP20B86
SC-023A
It takes a long time to turn on, when it does turn on it doesn't tune channels and it takes a long time to switch functions.Diode 1n4148 d23, replace directly, measuring is good.Secam
LG21FU4RLG
M059C
+10.5 power supply low, with 6v. the+9 drops to less than 5v. the horizon does not fluctuate. (+110v.normal)Check r810 47r it changes to about 200r, it is under the power supply IC heatsinkreinaldo almeida
LG29FU6TL-L5
3 RGB strips at the top of the screenReplace capacitor c 304 no verticalmateusf
LG32LH35FD
TV blinking on and off until it goes into protection and turns offInverter board 4075 mosfets transistors defective.ReplacementJFR
LG32LG30R
TV without selector signalFaulty seletronicChanging the seletronic or the entire board. In my case, I only replaced the seletronic .JFR
LG20D90
Don't tune in to any channel!!!Capacitors with lost capacity in the same tuner!!!. replace everything for new ones. 47uf 16v...2.2uf 50v...0.47uf 50vbarnes
LGCP 20K70
Power supply ok, turning it on turns off the LED, it does not oscillate and quickly returns to standbyVer c 510Master Eletronica
LG21FJ6RB
It doesn't work, the stand by led comes on, when you press a key the led goes off, the relay hits as if it were going to turn on, but then the stand by comes on againDeflector coil - measuring the deflector with the broken wire at the terminal that is soldered together as the green wireWhen I looked closely, I saw the broken wire. It was still possible to recover it, but if not, just replace it.tts
LGLM-U2350A
Panel does not light up (display off)Q972 e q973Replacing themfofao
LGRP 21FE85
21FE85
I'm soundC.699 220uf 10vReplace the c699eletronica martins ubatuba
LG29FS4RLG
CW62
+b enters and then drops until it reaches 0v, and the power supply keeps hissing.C 826 1000/10v elect shortedGood tip from josé gusmão, but I replaced it with a 1000/35v oneÁdrian Chapadão do Céu-Go
LG14SB1RB
Normal audio fabric offResistor that feeds vcc of +9v from rgb pin 11 of ic 501, cause of burning c511 of 100uf and 10v in shortChanging the resistor r529 and c 511 tv ok good luckgeorge pontes