PHILCO TV Repair: Common Faults and Solutions.
Search: PHILCO
Results: 4741
Results: 4741
PHILCO Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
PHILCO | TPF-2140 | When turned on, it arms the horizontal and disarms it. and the LED is blinking | C715 of 6k8 x 1600v as low capacitance | Replace the same | gilsce |
PHILCO | PCM 1446 | Does not turn on and the LED is flashing, +b low (40vdc+/-) | C 911 - 220uf x 160v | FERNANDO S | |
PHILCO | TP2010 | Sometimes it turns on, sometimes it doesn't. The stand by LED is blinking. | Resolder capacitor c922 of 100x160v. | nachbar | |
PHILCO | PCM-2046 | When turning on the LED blinks and with each blink the screen closes in the center, until it closes for good and has a thin, low hiss along with low pops | The TV had all normal voltages with the exception of the video's 180v - change the r715 c718 and d701 r713 r714 c723. note: the 4.7Ω r715 must have a tolerance of 5 percent because if the resistance is greater we will not have 180v but rather a different voltage, as that is what happened, I placed a 4.7Ω resistor that should have been with higher resistance and for this reason the voltage did not reach 20v so I put another one in parallel with 10kΩ and then 185 v appeared. | ||
PHILCO | TP2052N | Blowing fuse | Short q901 and also resolder, c906, c907, d907, r902, fb901, c908 and r908. | This email address is being protected from spambots. You need JavaScript enabled to view it. | |
PHILCO | TP2053 | No sound, when the channel was changed the sound came back, but the defect always returned | Cold solder on the sound output | Resolder sound output ci and surrounding components, including smd | alexsts |
PHILCO | TP2054 NãO TEM | Stand by and TV doesn't turn on | Power supply of plus b with 10t8 volt and +b 10 volt and - b 10 volt | Replace r 706 of 2k2 which goes to pin 33 of ic 101 | luiztvsom |
PHILCO | TP2054 | Dark screen with only characters, whether on the av or channels | Replace r303=4r7 smd | This email address is being protected from spambots. You need JavaScript enabled to view it. | |
PHILCO | PCS 2956 | Doesn't start | C 921 1k/1kv ceramic capacitor (blue) | After removing the shorted capacitor, the TV turned on and quickly turned off, only when adding another capacitor of the same value did it start working again. | José Gusmão |
PHILCO | PCM-1444 | Does not turn on or off with the remote control | Q904 | Moraes | |
PHILCO | PT 1554 CP02 RO | TV defect has no image in 15 seconds | TV turns off without showing image just plot | Ci power supply ic 901 tda16846 p d 909 short burn r 910 and 912 | Everardes |
PHILCO | PCM2051 | Sometimes it turns on and doesn't turn on and when it turns on over time it turns off by itself. | C708 ou c709 | Sandro T Grachet | |
PHILCO | TP 2054 | Dark screen with sound and menu ok, | Cause diode leakage d 602 | ELETRONICA ROBSON(DEBIQUE) | |
PHILCO | PCS 2956 | Vertical closed | Vertical was burned out, I replaced the vertical, it remained closed | R 709 open 1r | negodrama |
PHILCO | TP-1452N | Volume increases only in 3 stages | Program memory or press the channel +/- key and plug in for 15 seconds and adjust | ELETRONICA ARNI L. LEAL-SC | |
PHILCO GRADIENTE | TODOS DE 29'' TODOS COM MICRONAS | Transistor h burns out for no apparent reason | Check, change all filter+b capacitors of driver h | Place bu that supports higher current and higher peak voltage | josé carlos |
PHILCO | TP14U56 | Normal image then goes dark and tsound is only sound | Diode d 602 altered | This email address is being protected from spambots. You need JavaScript enabled to view it. BRUNONIKACIO@HOTMAIL | |
PHILCO | PC1444 CPH05 | Ugly image (no contrast) no sound. | Tda8361 with internal defect | Replace the tda8361 e5 | josé carlos |
PHILCO | PC1444 CPH05 | Image shaking, synchronization and missing color | Change cap 205. exhausted 2.2mf 50v | josé carlos | |
PHILCO | TP-2052N | TV asking for password, in my case it asked for password on channel 3. | Reset to memory. | Press the channel + and channel - keys and plug in for 15 seconds. | This email address is being protected from spambots. You need JavaScript enabled to view it. ELETRONICA SÃO FRANCISCO |