PHILCO TV Repair: Common Faults and Solutions.
Search: PHILCO
Results: 4741
Results: 4741
PHILCO Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
PHILCO | TV PH21B | Vertical fully closed even after changing la78040b | Measure the power supply if it is below 20v, clean the glue from the VD564 and VD566 diodes | Take the diodes out and clean the glue if possible, clean the area with thinner | antonio nobrega(patos pb) |
PHILCO | TV PH29 | Doesn't start | Power supply burning the strw6556a and primary diodes and fuse. | I put the strw6556a in and it burned again, when I turned on the TV with the 150w lamp in series then the TV didn't burn the strw and showed smoke coming out of the replaced c-553 (471/1kv), changing the c-553 tv went back to work perfectly. | Adilson(formiga-mg) |
PHILCO HITACHI | PC1438UO1436 CH04 | Tuning goes out when turned on when it heats up normal account | Defect | abias amorim silva | |
PHILCO HITACHI | PC1438 CH04 | Tuning goes out when it turns on when it gets hot it returns to normal | Defective tv | abias amorim silva | |
PHILCO | PCS 2956 | When I turned it on, it turned on and at the same time turned off, that's when I realized it was entering the protection system | I removed the, q707 and it fused again | bonzinho | |
PHILCO | PCR2049 | Has sound and no image with character | Cause: shorted 801 diode | ||
PHILCO | PCS-3320V | Cup effect (rounded black line at the corners of the screen) | R-722-100Ω | Replace and go for the hug | samuel leite |
PHILCO | PCS-3320V | Burning horizontal outlet | Fly back (ffa97017l(1) ou ffa97035l) e d707(by222) | I just had to replace them and the defect was resolved. | samuel leite |
PHILCO | PCM2046 | It turned on and off without stopping with loud flashes and pops. | R715 of 4.7onhs open | alvaro | |
PHILCO | PCM2046 | After 10 minutes switched on, it disarmed with a low whistle | D302 with leaks code;1n4148 after the exchange there was no more disarming, it was fine. | ||
PHILCO | TP2053 | Dark screen in a few moments turns off and flashes stand by | Poor contact on the cable that transports RGB to the kinescope, resolder the vertical output. | guaracy borges | |
PHILCO | TP 1410 | When turning on there is sound and then there is no sound | Tda 7267 | Matões A. Tecnica | |
PHILCO | TP 1410 | Does not turn on stand by led | Memoria smd | Matões A. Tecnica | |
PHILCO | PCS2976S | LED lights up, does not activate via the power key, only via the channel key, but does not arm, just flashes once | I changed the eprom memory and it worked normally | Stay with God guys | LUIS CARLOS |
PHILCO | PCM-1444
PCM-1446
PCM-2044
PCM-2046 CPH05 | When entering the automatic tuning menu, it does not perform the channel search operation, returning to the menu | Memo | Replace ic memory | toninho da eletronica |
PHILCO | PCM-1444
PCM-1446
PCM-2044
PCM-2046 CPH05 | Red screen not blue screen | Ic memory | Memo | toninho da eletronica |
PHILCO | PCS-2076S | The screen goes black with three lines of green, blue, red and sound. | R708 check the 45v fly back. | Replace this tip works for maxvision, platinum, emotion too. | Edigar de Souza Moulaz |
PHILCO | PC20R42 | Entered into protection, only turns on if unplugged | Defective deflector coil | Replacement | Eliel Magno |
PHILCO | PCM1444 PCM1446 PCM2044 PCM2046 | Alloy with retrace lines on the screen, loud speaker emits a light on the flech-like screen | Capacitor c719 10mfx250v | C719 10μF x 250v | toninho da eletronica |
PHILCO | TP-1452N | Without tuning channels (completely off air) | Mf201(next to the video ci) | Replace the same | Jarbas (ELETRO-SERV) |