PHILCO TV Repair: Common Faults and Solutions.
Search: PHILCO
Results: 4741
Results: 4741
PHILCO Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
PHILCO | PH21 M2 TUBO | When plugging the TV into the socket, the LED lights up, and immediately turns off, and nothing turns on. tensions in the secondary of the choper, in the absence of tension in the horizontal | Voltage up to c568 (47/160). cause, r470 of 3w 1.2r or 1r2 open. it did not provide +b for pin 4 of the fly. | With the replacement, it worked. Resistor difficult to find, you won't find it in every Philco chassis. | Marcos Lizzi, Confresa, MT |
PHILCO | TP14U56 55 02 F6949 06 2 | Without image, with osd and sound | Replace of zd701 20v and r723 10k | Eudes | |
PHILCO | PH32M DTV | I'm sound | Capacitors c314 and c319 | Eliel Magno | |
PHILCO | PH32F33DG- VB | Does not tune the channels. | Electrical surge. | Resistor r103 (1r0) open. | RNSPTEC |
PHILCO | PH21 SS | Vertical closed but with normal tensions | C402 | Replace c402 | otacilio |
PHILCO | PH32U20DSGW | When turned on, the screen flashes and returns to standby | Capacitores c1d2 470x25v, c2d3 100x50v e c2d1 100x50v | Eliel Magno | |
PHILCO | PTV32E20DSGWA LED | Totally inoperative does not light isadbay | Zdd5 shorted smd same replacement | Zener diode replacement | ELETRONICA SALES.NATAL RN |
PHILCO | PH24D21 TP.VST29.P9A | Turn on and off | Oxidation in ci with 5 terminals close to eeprom | Remove the oxidation and resolder it | Multimarcas/Acarí |
PHILCO | PH21SS | TV turns on with no image, opening screen with list in the center of the screen, 5cm missing on both sides. | Cap 312 220x16v shorted on pin 3 of the uoc micro controller, the TV returned normal. | guinga sdia goias | |
PHILCO | PH40R86DSG | No image. audio only. | 3 defective LEDs. changing the LEDs. | I reduced the inverter current. I removed the resistor rw819 (1r5). the measurements were 65.5v dropped to 63.2v, and the current was 307ma dropped to 243ma. | Eletrônica R-Tec |
PHILCO | PMS24 | When opening the door, the light turns on and the prosto and fan rotates | Main relay below the transformer | Ahumaky | |
PHILCO | PH28S63D | Does not turn on, no stand by. | C8 shorted. | Replace: c8, r20, q2, f1, r15(10r smd), r15a(10r smd). | electronicssupplyparts - Gramado/RS |
PHILCO | PH39R25DSG LED | Sound without image back in the background | Burned out LEDs and diode on the power supply board | Replace LEDs and the d10 diode of the power supply | Tec center |
PHILCO | PH32U20DSGW | Doesn't start | Diode dp202 - primary power supply | Pardal - X | |
PHILCO | PTV55U21DSWNT | No image and the screen LEDs do not light up | At the power supply in short d27 and 29 (sb5200 is scotly) | Replace the diodes | SANTOMEL |
PHILCO | TP1452N | Completely turned off, the power supply with a filter capacitor voltage of 300v, 12v power supply zeroed. | 470k open resistor | Substituir | Matões Assistência Técnica |
PHILCO | TP20V56 | Dark screen with normal sounding characters | Dz-701 shorted next to flyback | Replace it for another like it | ELETRÔNICA CAVALCANTE MARTINÓPOLE-CE |
PHILCO | PH32M2 | After a while on, the image goes out if you change channels, it comes back for a while again | Ca8-ca15-ca12 100/25 | Replace of 3 | MARCELIO DREISSIG |
PHILCO | PH21M2 TUBO | TV doesn't turn on, nor does the LED light up. total stop | Tsound is food in primary, but not in secondary | Replace the power supply strw, then, ok. resolder everything to give the device more life. | MARCOS lIZZI Confresa, MT |
PHILCO | PH21MSS | It turned on with everything normal, but nothing was tuned. | C832 electrolytic 1000uf by 25v stewed. | Replace the component. (edfersom) | EDFERSOM |