PHILCO TV Repair: Common Faults and Solutions.
Search: PHILCO
Results: 4741
Results: 4741
PHILCO Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
PHILCO | PH21M SS | The TV arrived without turning it on, just with the LED on, when I pressed the power key it turned off the LED and turned it on again but it didn't turn on | The cause of the defect was the shorted vertical ci tda-78141 | After changing the ci the TV works again | ASSISTEC |
PHILCO | PH21C | Turns on and off, works, the image appears and turns off | Replace r315 10k, see also, r316 5k6 next to vertical discipient and c317, r274 | DJ PITUKA | |
PHILCO | PH21C | Does not turn on, nor does the stand by LED light up, power supply defect | Replace transistor q801 2sc1815 | DJ PITUKA | |
PHILCO | PH21US A1 | Turning off | Transistor v502 e capacitor c580 | 3R | |
PHILCO | PH21M2 SS PH08K-C01 | Horizontal bar, image folded horizontally | Zd483 (9.1v) | RICHARDO SILVA | |
PHILCO | PH24D20DM2 SW10 | Turns on but no image | Q813 on main board open | Replace him | barbadinha |
PHILCO | PH21MSS | Image stretched horizontally | Replace diode d454 fr104 next to the deflector connector | DJ PITUKA | |
PHILCO | PH32E31DG | Restarting, as if it needed to be updated | On/off switch (joystick) | Krul | |
PHILCO | PH22S31 | Does not turn on standby | Changing the photo coupler and the 431 on the side | RMSELETRONICA | |
PHILCO | PH1100M | It starts hello and sometimes it just stays LED STBY | Ce 5,ce6,ce2,ce8,ce7,all change 100mf 16v put 470mf,it is located near the connection with the power supply on the main board, it feeds 5v,vcc pin,check the 1,2 and 3v smd regulators | AF-SAT Eletronica | |
PHILCO | PH21 US A1 | It turns on with the image shaking and the TV speaks and then the voice disappears. | Shhha | Replace the capacitor c507a and just run to the hug. | Sinailson furtado |
PHILCO | PH20U21D LED | Does not work without voltages in the secondary | Cap smd723 | Replaced | eletroberger |
PHILCO | PH28S63D | Sound failing when increasing | Smd transistor q3. on the main board. 12 volts from the audio ci keeps oscillating. | Ozatec electronica sarandi / pr 12/23/2019 | OZATEC ELETRONICA SARANDI / PR |
PHILCO | PH49F30D | Does not light backlight | Vw10 or vw09 shorted diode. | Replace | Hndrsn |
PHILCO | PH21M | Working, but with a buzzing sound in the power supply transformer, sounding like a cricket. | D-802 as leak. | SANTANA | |
PHILCO | PH28T35DG | TV turns off after a while of use, intermittent sometimes | D201 | The audio ci was getting hotter than normal at low volume, I threw heat on it with the blower and the TV turned off immediately, I replaced the d201 which looks like a transistor and it went back to normal. | AlanCocteau |
PHILCO | PH28T35DG | TV turns off after a while of use, intermittent sometimes | U501 | The audio ci was getting hotter than normal at low volume, I threw heat on it with the blower and the TV turned off immediately, I replaced it and it went back to normal. | AlanCocteau |
PHILCO | PH21US A1 | It doesn't turn on, the stanby LED is flashing and the power supply has 56v on the secondary | Change resistor r514 36k, next to the regulator strw | DJ PITUKA | |
PHILCO | PH21SS | Carbonized components r448, c437,vd435,c450 | Change the r448 of 22k c437 of 471k for 2kv the vd435 in place of this diode works a capacitor of 471k for 2kv also change the capacitor 450 of 681k for 2kv | 2kv, the vd435 instead of this diode works a capacitor of 471k by 2kv also replace the capacitor 450 of 681k by 2kv | Sinailson furtado |
PHILCO | PH21SS | Don't turn on the power supply mocking | R470 e o vd435 | Replace the 1r2 r470 that sends 130 volts to the +b and also replace the 471k polyester capacitor for 2kv that will be in place of the vd435 diode and then just run for the hug. | Sinailson furtado |