PHILCO TV Repair: Common Faults and Solutions.
Search: PHILCO
Results: 4741
Results: 4741
PHILCO Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
PHILCO | PCS 2700 | Replace without testing and run for the hug!!! | Bf 423 on the fly back side + 10uf x 50volt capacitor in front of the bf, if you remove the scr from the board the TV even works but is left without protection. | Replace without testing and run for the hug!!! | EDGAR THIZ |
PHILCO | PC 1445 | Does not tune channels | Ic - 102 (80011a) . memory | Replace the same | BARRETO CRUZ |
PHILCO | PH14 | Doesn't start. | Memory. | If you put a virgin on, the TV turns on, however, tsound is no sound. You have to put it already recorded. | R-TEC Eletrônica |
PHILCO | TP2054 | I didn't get normal AV channels | Sf 201 | Replace sf 201, and run for the hug | chines eletronica/ solanea PB |
PHILCO | TP 1453 | Turns off standby, flashes quickly and turns on standby again, and doesn't turn on | R 750 3k3 oscillator | pedrinho tela quente | |
PHILCO | PH29MSS MA1 | Low power supply, LED flashes when the keys are pressed | Transistor q808 | To replace | kleber show |
PHILCO | PH29M SS | Turns on, discharges and turns off. LED keeps flashing and no longer turns on. | C846 47x100 | Swap c846 | TonicoBH |
PHILCO | PCS-2952 | After a while it is on, it turns off and tsound is noise at the power supply.... | Replace cap. 220/200v... | ||
PHILCO | 2044 | Upper vertical lines looks like a 100uf capacitor but it is not | See r 610 open | Master Eletronica | |
PHILCO PCM | 14 | Vertical closed a little at the top and a little at the bottom with a luminous streak at the bottom | Eprom It's just replace | MARCIORVGO | |
PHILCO | PCS 2976 | Turning off when changing channels and vertical a little closed at the top | I replaced the 39u 250v c728 with a 53u 250v and it is working perfectly, as the 39u was replaced and nothing happened, even the channels gained performance! | Fabiano | |
PHILCO | PCS2952 | This TV had a leaking flay back, I replaced it and when I turned it on the TV it had a red screen I thought it was the resistors on the kinescope board but it wasn't. | I had to do a procedure that is as follows: turn off the TV in general and hold down the two channel keys and turn on the TV, and hold for three seconds, and everything will return to normal. | ELETRONICA DIGI SOUND, NOVA TIMBOTEUA PA | |
PHILCO BRITANIA | PH14D | Led flashes radido No start r839 82k rising c 843 c 845 also varies in memory | Grava eprom | PHILTEC | |
PHILCO | TPF2121 | The LED turns on, presses power, the LED goes off for a few seconds and starts flashing | Wide capacitor | edezio eletronica | |
PHILCO | PH21M SS | ñ league not led | Diodo zener 18v q 802 r402 r846 10Ω d 811 | Replace e so file | fofinho |
PHILCO | TP2052N | Doesn't start | Power supply transformer with loose ferrite and open r921 and 923 | Paste trafo and replace resistances for 1r | ELETRONICA MAURI JUNIOR |
PHILCO | PH21SS | Vertical closed at the bottom | -13v missing from the vertical diode with poor contact and 1000/25v capacitor with low capacitance | orlando lott | |
PHILCO | PCM-2046 | LED blinks and doesn't turn on | C911 sold out | Replacement | beto |
PHILCO | PH21D | Turns off after turning on | Excessive width, high power supply with 130v instead of 105v | Test r 839 82k replaced to 100k. | LOU |
PHILCO | TP2052 | Call whenever you want | Trafo from sole nucleus power supply | Glue and tape | ELETRONICA MAURI JUNIOR |