PHILCO TV Repair: Common Faults and Solutions.
Search: PHILCO
Results: 4741
Results: 4741
PHILCO Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
PHILCO | PH21M SS | When turning it on, the LED flashes, +b changing to 24v | D818 =fr104 shorted | Replace it and run for the hug | hipereletronica service (maraial-PE) Marcelo |
PHILCO | PH 21C | Turns on with vertical closed, then turns off | D 810-replace open diode | MARCELO JOSE | |
PHILCO | TTV PH 21C | TV does not turn on any voltage on the secondary | Zener diode 12v short non-primary d821 | Darci Fuhr | |
PHILCO | PH24A | Does not turn on, power supply stopped | C203 (2n2/ 1kv polyester capacitor) shorted | Aecio Flavio | |
PHILCO | PCS2956 | Risk on the image, better known as the delay line, which is generally seen on the c728 3n3 1600v | C728 3n3 1600v was replaced | gerson tomaz | |
PHILCO | PH29 | Does not turn on low power supply | Zd804 (4v7) | mega center | |
PHILCO | TPF-2922 | Vertical burnt out, the biggest problem to fix, I used a similar part and it never worked. | The resistor that comes from the 50volrs of the flyback is 18r and the ci tda8177f or tda9302h tsound is no point in putting the tda8177 | Put the correct parts and that's it, blz | fabiusmax |
PHILCO | PCM-2046 | The standby LED doesn't turn on, it's flashing, only the flyback is defective, be careful friend, even with the +b and the bu disconnected, the power supply is low @@@ | Flyback | ELETRONICA ARNI/LEOBERTO LEAL-SC | |
PHILCO | TPF2922 | Burnt resistor r709 | Value of resistor r709 is 18r 1/2 if you put lower values it will burn type 1r it will catch fire | fabiusmax | |
PHILCO | PCM-1451 | Call whenever you want, it seems like a bad connection | Intermittently turns on and off... | Changing capacitors c 709, c708, changing both without measuring.... | Adriano,rio verde,MS |
PHILCO | TPF2121 | Altered power supply, (+ b quese 170 volts.) triggering protection. | R919 - (120k) fully open. | Carlos Maia | |
PHILCO | TPF2121C | Vertical closed | Chap. c614 shorted 47nf ceramic | Replace component note: short on the scale x1 this one is actually shorted, hugs | FABIUSMAX |
PHILCO | TP20V56 | Image disappearing brightness, starting at the top, normal sound. | D 602 as leak | aelson | |
PHILCO | PT1410 | Inoperative, led off. | It was the broken q901=stp9nc70zpf mosfet, ic901=ta1507p, r918=2k2 starting. I changed it and left for the hug. | ELETRÔNICA MELO BOA VIAGEM -CEARA | |
PHILCO | PCS-2700 | (correction) TV without +b on the secondary, with blinking LED | As previously reported, the capacitor (c 720) is not 10uf but 47uf | Ademar / Videira sc | |
PHILCO | PCS-2700 | TV without +b on the secondary, with blinking LED | Change the electrolytic capacitor (c-720) 10uf x 25v located inside the vertical heatsink | Ademar / Videira sc | |
PHILCO | 2956 | Turns on, turns off then arming protection | I realized that it didn't have filament protection, then I discovered that it had 180 volt protection, so I turned off the 10k r725, it worked better when reduced, I found the c1703 changed, I changed it and ran to hug it, then I turned it on to the r725 and it was fine | ||
PHILCO | PH21B | Turning off and on | Strw6553 replacement | Strw6553 replacement | fco |
PHILCO | TPF 2121C | Colored vertical lines at the top of the screen and then turns off | Capacitors c 914 and c 918, with loss of capacitance. | Replace them | ÁVILA |
PHILCO | PH200 PH200 | Inoperative, nothing lights up | Audio output short tda7265 removing the ci the device turns on | Replace the tda7265 | carlosss |