Search: PHILIPS
Results: 14169

PHILIPS Repair Guide: Common Issues and Fixes

Brand Model Fault Detailed Problem Solution By
PHILIPS29PT4635/78
L01
Turns on the image and after about 10 seconds it turns off and only turns on again by unplugging it.Resolved by exchanging the original kinescope, luckily I had one like it, it left zero bullets.JOSÉ BENICIO
PHILIPS29PT5645/77
Does not light up stand byPhotocoupler replaceINOCENCIO
PHILIPS29PT4635
Bu 4508 dx heating up even after replacing q 7461, q7463 and c 2455I removed the two new transistors and put two from scrap and bingo. solved the problemThe transistors are even new, but they don't work well on this particular TV.antonio nobrega (patos pb)
PHILIPS20PT529A
Little contrastResistor 3425 (16k)Replace of r 3425 (16k)Rafael
PHILIPS29PT9467C
SK5.1L
No shine, just a few lines on topSem +16,2v no pino 3 do ic 301D452 openjasvan souza
PHILIPS20GX1656
Flickering imageZener diode 15v, dz6519 15v 1w shortedReplace it for anotherhipereletronica service( marcelo)
PHILIPS29GX1898
Volume bar goes to a maximum of 3 pointsTV is in hotel modeTo remove it from hotel mode, set it to channel 22 (it does not need to be tuned in), press the volume(-) and channel(+) keys simultaneously.Alisson
PHILIPS32PFL3403
Doesn't startRemove c922 on the power supply boardSee other defects on page 24itan
PHILIPS20GL1045
Strong whistle only in STBY, when activated CR turns on and works normally.Voltages were all normal at the power supply, I suspected the capacitors, but they were all goodReplace power supply chopper transformerELETRÔNICA ESTUDIER - CANOAS RS.
PHILIPSFW-C507
Cd spins twice and doesn't read4r7 at r.3835Just replaced it and it was okFábio Andrade
PHILIPSFWM396
Low outputs don't workHe growled indignantlyReplaceVITALTEC
PHILIPS14PT414/A
Device does not work, tsound is no +b in the power supply secondary, transistor and ci are good.Open 22 r resistor, position, 3525, biases the gate of the power supply transistor. Replace it, it's ok.TECNOSAT ELETRÔNICA E INFORMÁTICA, JATAÍ-GO, This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPSFWM779
Device turns on and off after a few seconds. If you turn it on with the voltage selector switch to 220v on the 127v network, the radio works.Voltage regulators 7500 and 7504Resolder the terminals.EDSON DE SOUZA AGUIAR
PHILIPSFWC-507
No sound with everything workingVoltage on pin 12 of the output above 25v, transistor 7304 (bdw94) shortedChanging transistor 7304 (bdw94), sometimes the fet 7309 (stp60ne06) also causes thisbakaninha
PHILIPSFW-C507
No sound with everything workingVoltage on pin 12 of the output above 25v, transistor 7304 (bdw94) shortedChanging transistor 7304 (bdw94), sometimes fet 7309 (stp60ne06) also causes this.bakaninha
PHILIPS29PT9467
Does not turn on and/or turns on with a whistle and/or noise in the horizontal position, possibly the sh is shortedCheck short in fly secondary, probably vertical IC tda 4865aj can use tda 4863ajMaster Eletronica
PHILIPS170S
Monitor turns on, shows a red screen and then turns offBacklight lamps (test with the inverter power supply)The faulty light bulbs were replaced and the monitor started working again.Gilnei
PHILIPS21PT5435
Turning offC2492-c2461-c2440C2492-c2461-c2440ELETRONICA MAURI JUNIOR
PHILIPS21PT5433
Turning off by itselfSwap c2492 - c2461-c2440C2492- c2461-c2440This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPSFW-780/19
Noise in channel r with sound at low volume.Capacitor smd 2602Replace capacitorDEBIQUE