PHILIPS TV Repair: Common Faults and Solutions.
Search: PHILIPS
Results: 14169
Results: 14169
PHILIPS Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS | 29PT 9467 | Vertical closing at the bottom | Change the vertical output | Tda 4865aj | DEBIQUE |
| PHILIPS | 14GL1310 GR1-AL | Completely gray screen with retractions. | R-550 = 4,7r x 1/2w ( pino 1 do fly-back ). | FERNANDO S | |
| PHILIPS | 21PT5433 | Closed image with dash at the bottom of the screen | Q 7463 c546b | Replace´lo | Marcondes, jaicós-PI |
| PHILIPS | 21PT6456 | LED does not turn on | Horizontal output open = after changing it burned again after short flyback test | Changing horizontal output and flyback was ok | ELETRONICA MAURI JUNIOR |
| PHILIPS | 21PT6456 | Turns on appears vertical strip at the top of the screen turns off without image and sound | Picture tube killing screen voltage | Replace picture tube | ELETRONICA MAURI JUNIOR |
| PHILIPS | 29PT4641 | Vertical only opens at the bottom of the screen when you want or opens with a vertical strip at the top of the screen | Replace c2465 d6457 | D6457 colocar no lugar 1n4148 = c2465 22x250v | ELETRONICA MAURI JUNIOR |
| PHILIPS | 21PT6456 L03.1L | Vertically closed, opened 2 fingers and closed (pulsing) | R348 of 1Ω open | When I replaced it, it stopped pulsing and tsound was just a closed vertical line. I discovered an interrupted track that was supposed to connect the r3470 with the 2470 capacitor. This track passes under the 7466 smd transistor. I replaced the bc546 7463 and it opened halfway up, I then discovered that the 56n capacitor c2460 had a broken track when I reconnected the track everything was ok | JOSÉ GUSMÃO |
| PHILIPS | GL1019 | + b instead of 70 v it had 30 v and it didn't turn on | Believe me short sound output tda 7052 | Replacelo | antonionobrega(patos pb) |
| PHILIPS | VARIOS MODELOS | TV doesn't work, keys don't work, control doesn't work with the factory message | 89 keyboard and OSD on control | This email address is being protected from spambots. You need JavaScript enabled to view it. | |
| PHILIPS | 29PT4641 L04U | Vertical open only the bottom | Smd resistor 3465 and 3464, the chassis only has one of the resistors | jedvaldo | |
| PHILIPS | 20PT3331 | Turns off in a row | Cause: 1k 2318 smd capacitor defective | klein | |
| PHILIPS | 32PFL3403 | Turns on and off randomly | Substituir as r 602,603,604 | Place 01 1m resistance in place of the three | ELETRO CENTER |
| PHILIPS | 150S | Turns on and off, sometimes holding down the keys works for a while and then turns off. | Defective digits | Replace all digits | Valmon |
| PHILIPS | 29PT4631 | Lines top of image | C2480 and c2487 obs. replace both | This email address is being protected from spambots. You need JavaScript enabled to view it. | |
| PHILIPS | 29PT5642 | The TV turns on right after it turns off and goes into protection, the image does not appear, but if you increase the screm, a vertical strip appears, not in the center, further down, but vertically closed. | R3606 auterated 56k resistor supplies the 5v to the hercules. | Resistor replacement. | play back |
| PHILIPS | 20PT3331 | When you turn on the TRC it turns green and then turns off (it goes into protection) | Poor contact on the r g b e board (in other cases it is the socket) | Soldered the whole board and it works normally | DIGITEC ELETRONICA Lambarí D'oeste -MT |
| PHILIPS | 32PFL3404 | With sound without image | Cf01 | 220n | This email address is being protected from spambots. You need JavaScript enabled to view it. |
| PHILIPS | 14GL1319 GR1-R03 | Weak video, no contrast, image varying, does not fix the effect | Open resistor r3215 | Calixservice | |
| PHILIPS | 21PT5433 | This TV had no image, only sound, and turned off in 5 seconds. | Checking the voltages, the voltage of 5 volts was not found on her ht so I checked the beautiful heart which comes out of pin 5 of the flay back and passes through two resistors 3443 and 3444 both of 1Ω and goes to the diode 6444 | The problem was the resistors 3443 and 3444 which were completely broken, I just replaced them and the 5 volts came out on the TV and the image went out in the file | This email address is being protected from spambots. You need JavaScript enabled to view it. de governador valadares |
| PHILíPS | PFL3403 | Off, no stby. power supply zeroed. | D2 rectifier bridge and 5a fuse and 1a fuse. | The rectifier bridge and fuses were replaced. | Sérgio luiz martins |