PHILIPS TV Repair: Common Faults and Solutions.
Search: PHILIPS
Results: 14169
Results: 14169
PHILIPS Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS | 29PT9467S | TV with normal sound but no image, completely dark screen, 0 volt screen | Shorted tube | I replaced the tube, problem solved | luziano basso |
| PHILIPS | 29PT9457B | Dark screen with colored vertical lines (vertical closed), and then turns off | Shorted smd capacitor | Replace the 10n smd capacitor c2461 (use diagram from 29pt9457) | Eletro Center |
| PHILIPS | 21PT9467C | Turn on and off | Ic 102 tda9373ps-n3-a | Replace | ELETROCLAUDIO AGUAS BELAS |
| PHILIPS | 29PT4635 | No image with characters | Tsound micro | So replace | orlando |
| PHILIPS | DVP3124 | It doesn't turn on using the panel button, just the control, and it can turn itself off | Check the voltage on the pci mother pin 3 connector for the front pci it should be around 2v4 if it is low it could be c75 smd with a leak near the connector. | Bruske | |
| PHILIPS | 20PT3331 03.1L | I'm sound | Capacitor smd c2201 aberto | Alvaro (prolar) | |
| PHILIPS | 29PT4631 | Power supply does not start, power supply oscillator power supply with low voltage on pin 1 (from 13v to 6v) | Photo coupler | Ronie Grein | |
| PHILIPS | 20PT120A L7 | Does not tune channels | Without catching channels | R3617 12k open | dede som |
| PHILIPS | 40PFL3605D | Won't turn on, fuse blows | Q501, d510, r517, d210 | Ronie Grein | |
| PHILIPS | FWM570 | Heating and burning transistor 7211 pzt 2222a | Diode 6108 12 volts with leakage | Take it off the board to test because on the board it measures as good | antonio nobrega(patos pb) |
| PHILIPS | 21GX1668/78 | Poor contrast | R3460 changed | Replace | deuner |
| PHILIPS | 20PT3336 | Dead | Floor 6765 | Replace the same | eletronicaapolo |
| PHILIPS | 20PT228 | Nothing works, the stand bay LED doesn't even light up | Secondary supply +b low oscillating from 50v to 67v | Replace do ic 7520 (tea 1507) | LOU |
| PHILIPS | 21PT9467 | Image closes after a few minutes | Deflector | Adjustment or replace. | LO |
| PHILIPS | 20PT3331 | Vertical closing at the top and turning off after a few seconds | Drained 2460 capacitor | Replace for a good one. | Ademir solânea pb |
| PHILIPS | 14PT3131 | When cold... in a few more seconds it turns off, but when it heats up it works normally. | It could be the vg2 that is out of adjustment, adjust the vg2. | jayjunior | |
| PHILIPS | 21PT8467/78 | Turns on then turns off triggers protection | Rusty tube no g2 | On g2 it oxidizes and shorts out g2 and with the g2 wire give some sparks to the pin obs. resolve, but the defect may return again (be careful when notifying the customer) | arasonic |
| PHILIPS | 20PT122A | Don't tune in | Eprom | Rewrite eprom data | DIGITAL TEC ELETRONICA |
| PHILIPS | 14PT3336/78 LO6 11 | Blue screen with traces and then turns off | Kinescope socket with humidity, due to relative humidity on rainy days and oxidation on its internal terminals | Replace the kinescope socket with new and good quality | PAULO SERTEL ITARARÉ SP |
| PHILIPS | 14PT3336/78 L06.1L | Blue screen with traces and then turns off | Socket with humidity, due to relative humidity on rainy days and oxidation on its internal terminals | Replace the socket with a new one of good quality | PAULO SERTEL ITARARÉ SP |