PHILIPS TV Repair: Common Faults and Solutions.


AIWA
BEKO
CCE
CINERAL
DAEWOO
FUNAI
GRADIENTE
GRUNDIG
HISENSE
HITACHI
ITT
JVC
LG
MITSUBISHI
PANASONIC
PHILCO
PHILIPS
PIONEER
RCA
SAMSUNG
SANYO
SHARP
SONY
THOMSON
TOSHIBA
VESTEL


Search: PHILIPS
Results: 14169

PHILIPS Repair Guide: Common Issues and Fixes

Brand Model Fault Detailed Problem Solution By
TV PHILIPS29PT458A/78
*		When the TV heats up +/- 1 hour of time it turns off, after this time it starts to turn off continuously and then it doesn't obey but nothing starts working again only if it is turned off with the main switch and everything comes back on again.Encontrei q7450(smd) proximo do flay backI put bc 547 and it was normalwagner
PHILIPS20PT120A-PT110-PT210-PT121-PT220
This TV turns on the power, the standby LED blinks about 5 times and does not turn on the power supply +b 95v ok @@@Resolder or no smd c2442Help yourself leave your tipELETRONICA ARNI-LEOBERTO LEAL/ SC
PHILIPSAS 800
Turns on the display and goes off and only the stop is onOpen transistor t 7252 and open resistors 3333e 3334 and 3300 and 9601carlos jpramos
PHILIPS29PT9467C/78
L 5.0		Half-closed vertical lineL 108 open on pin 39 of the microChanging the same...tip from my friend SÈrgio Maniero last December...it worked for me despite the symptom being different from his...sansão1
PROVIEW /PHILIPS29 N 6 P
Without high voltage, with sound and cannon off but the power supply works perfectly.Resistors with heat changes the value (resistance).Replace resistors r467=10k/2w and r703=10k/2wDé Andrade
PHILIPS29GX1899
The moment it turns on, sound, video and color come on, after 3 seconds it becomes colorless and the screen darkens and cuts the sound, changing the channel repeats the same symptoms again, the screen goes dark but the loudness continues.Faulty eepromReplace eeprom with data.Ademir tc
PHILIPS28PW6506/01
L01.1E AA		Horizontal opens the width poorly, side dth becomes narrowerVer e mudar c 2405 220uf 25v c2455 47uf 35vPingo
TV PHILIPS29PT 6566
L04-AA		Reduces the frame by giving 3 colored lines at the top vertically and turning off after 5 minutesThe cause a r 3457 1r openjose ferreiras
PHILIPS21PT1663/11
L7.2E		After a few minutes the image begins to slowly shift to the right. when it gets close to the center it goes into protection and goes to stby.Deflector coupling capacitor h leaking. 220pf 2kvJoaquim Monteiro
PHILIPS32PFL3403
Won't turn on, fuse blownCheck leak in bd1, and its replacement.BRUSKE
PHILIPS21PT5432
Doesn't startPhoto coupler position (7515) changeCHARLES
PHILIPS20PT529
Totally inoperative power supplyNothing works, not even the power LED lights upPhoto coupler 7515 swaplolo
PHILIPS14PT3336/78
L03.6LCA		Works normally, vertical only opens at the bottom of the screen, appears with a white line in the centerSmd 2496 1n0 capacitor shortedFUBUIA
PHILIPS21PT5433
Turning offOpen smd 6445 diodeReplace diodo smd 6445SIDNEY VALENTINA
PHILIPS - DVD PLAYERDVP3040K
Standby off1n4004 rectifier diode and 500 milliampere fuseThe diodes and fuse were replaced and the DVD started working correctly again.domingos.aladir
PHILIPS29PT4641
L04L AA		Noisy and low sound at RF and AV outputCoil 5214 that is connected to pins 120,122,124 that provides 3.3 volts powerCoil 5214 that is connected to pins 120,122,124 that provides 3.3 volts powerBarack
PHILIPS21PT5435/78
No image, just characters appearingReplace 3442 100k resistor - for 21" TVGelasio Altenhofen
PHILIPSHTS DVD E RADIO
HDMI		Doesn't turn on without more b + in primary and secondaryR937 openDevice came from another electronics well replaced, replace r 937luiztvsom
TV-PHILIPS20GL1349
Dark image and low screen voltage (+or-40 volts)Rusty trc socketReplace itThis email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPS20PT428A
Inoperative or very low power supply approximately 20 voltsLeakage in the power supply fet, leakage from pins 1 and 2 to 3, measure on a scale of x1, normal and gives a small resistance between pins 2 and 3Replace or fetRicardo Alves