PHILIPS TV Repair: Common Faults and Solutions.
Search: PHILIPS
Results: 14169
Results: 14169
PHILIPS Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS | 29PT5642/78 L04LS1 | Cvi (component video), with a reddish image even without signal. after eeprom change | Eeprom mismatch | Enter sam mode go to nvm editor, in the adr option select 0x003e 62 and replace the val option to 0x000f 15 (this value refers to blor (black level off-set red), if necessary also adjust the blogreen accessed by adr 0x003f 63 and changing the val to obtain the best black level (without signal) obs after each adjustment is selected select the option store?-> .to confirm the adjustment simply replace the function and return to cvi. | Wagner |
| PHILIPS | 29PT5642 L04LS1 | Comes with no sound, poor width, after a while normal sound | Checked pin 84 of the Hercules with low voltage (~4.4v). internal leakage in the pin only. solution: apply a 7808 regulator ci in place of r3975 (150Ω/1w), thus guaranteeing the power supply. I did this to avoid changing the ci (due to its high cost). | NelsinhoPira | |
| PHILIPS | 20PT3336 | No image, sound and normal osd | R-3442(100k) on the eht line | Marcelo Jose | |
| PHILIPS | 20PT228/78 L01 2LAA | Green screen with retrace lines and returning to the stand bay | Change resistor on tube board r 3324 on rgb line | Tecnico Jose Adriano | |
| PHILIPS | 20PT3331/78R | It's burning the 2k2 r3527 at the power supply! | Change the ci-tea 1506t at the power supply! | Luis Araujo (teia) | |
| PHILIPS | 29PT4641 | Image shifted to the left, i.e. image with a horizontal black band on the left side of the screen | C2486 ceramic of 27pf wsoundas the diagram shows it as 100pf | After the replace it was fillet. tip I got on a Spanish electronics forum | JOSÉ GUSMÃO |
| PHILIPS | 21PT5437/78R | With the white screen without image and thin horizontal stripes! | 100k 3442 resistor near flyback | Luis Araujo (teia) | |
| TV PHILIPS | 20PT3131/78R | The sound is low and does not increase with volume! | Remove the 6908 diode near the sound output! | Luis Araujo | |
| PHILIPS | 14PT218A | Tsound is just scream and over brightness and turns off | Flyback | Replace | EletroClaudio Aguas Belas Pe |
| PHILIPS | 20PT326A | Turning off solution change the flash back | eletrojacob | ||
| PHILIPS | 20PT326A | It turns on immediately then turns off, sometimes it took a while to turn off and other times it turned off as soon as it turned on | Flay back | Replaced it because the defect was internal to the screen | eletrojacob |
| PHILIPS | 29PT554 | Channels scrolling endlessly | Replace the channel touch switch and it's solved!!! | orlando | |
| PHILIPS | 14PT3131/78R | Vertical with black stripe and lines at the top of the screen | C2460(ceramic 68n/150volt) | Replace it as it is dry | jarbas santos |
| PHILIPS | 20PT3331/78R | Vertical black strip with lines at the top of the screen | C-2460(ceramic) seco | Replace it without testing as it is dry | jarbas santos |
| PHILIPS | 20PT3336 | TV with noise in the power supply drive | Str w6765 defective, you can put the w6750f and it will work | multsom | |
| PHILIPS | 20PT222A | Screen does not work correctly, retrace lists | R3341 100homs | Perse | |
| PHILIPS | 14PT4131 | The TV turns on and then turns off. the power supply voltage becomes unstable. | Capacitor c2528, power supply | Perse | |
| PHILIPS | 29PT L3 | Burning exit h | Capacitor 25 by 47 connected to the drive transformer | gemerson | |
| PHILIPS | 20PT524A/78R | Blinking LED with noise on fy back | Open power supply 47r r 3541 | Perse | |
| PHILIPS | 29PT552 | Defect: shutter effect, lower vertical | Capacitor c2409 changed 0.22 x63v | Perse |