PHILIPS TV Repair: Common Faults and Solutions.
Search: PHILIPS
Results: 14173
Results: 14173
PHILIPS Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
PHILIPS | FL1.7 | 100hz cross | Possible solutions: 1. interrupt on the ssp the 50hz y-signal, between pin 11 position ic7324 (tda4568) and pin 11 position ic7395 (tda8443), by deleting position 4302. repair the connection by means of a shielded cable of 16cm long, m | ||
PHILIPS | FL1.6 | Wrong synchronization, unstable colors | D6417 on the lsp dependent on temperature, check/replace (4822 130 81223) | ||
PHILIPS | FL1.6 | With fast moving picture poor picture quality (scan effect visible) | Change software into version v54 version or higher on control board 7115 (4822 900 10356). remarks : with this software it is possible to switch off lfr. | ||
PHILIPS | FL1.6 | Vertical position can not be adjusted. | Add position 3464 (1k8; 4822 053 10182) on the large signal panel between 1l30 and pin 9 of ic7450. remarks : the range of the vertical shift will be changed. introduced in production in week 9317. | ||
PHILIPS | FL1.6 | Vertical line interference on ch 2, 3 and 4 (spook). | General remarks: - place the antenna at a good distance from the tv set. - use good shielded cables, connectors and splitters. - avoid hf amplifiers, splitters and rolled-up cables just nearby the tv set. - the stronger the signal is captured the less p | ||
PHILIPS | FL1.6 | Unstable picture, horizontal jitter. | Check/replace r3405 on the lsp. (4822 051 10303 for 50 hz sets; 4822 051 10333 for 100 hz sets). | ||
PHILIPS | FL1.6 | Unsharp picture; vg2 varies with focus adjustment | Reset pulse rstn1 missing. ic7219 and ic7207 changed in lfr-box (4822 209 63892 and 4822 209 31056) | ||
PHILIPS | FL1.6 | Tuning does not function | Resistor r3240 on lsp in v-tuning wire broken. | ||
PHILIPS | FL1.6 | Totally inoperative. error code 9 | R3480 on ssp defect (4822 052 10278). | ||
PHILIPS | FL1.6 | Totally inoperative. | Transistors 7250 (bux85f; 4822 130 62509) and 7251 (bc848; 4822 130 61207) in microsops defective. or d6251 (llz-c5v6; 4822 130 80954) and r1250 (=r3230; 1Ω; 4822 052 10108) defective. or t7270 (bd825; 4822 130 41746) or t7201 (bc857c; 5322 130 427 | ||
PHILIPS | FL1.6 | Totally inoperative, +5v is not present. | Check ic7551 (4822 209 71825; lm358n). | ||
PHILIPS | FL1.6 | Total picture vibrates in vertical way, even on teletext. | Check pll signal on pin 26 of ic7219 on lfr box; if clock is 32.825 mhz; replace ic7120 (ic7220 in stocklist of service manual) (4822 209 31061; s87c652-sn40). | ||
PHILIPS | FL1.6 | Total picture vibrates in vertical way, even on teletext. | Check pll signal on pin 26 of ic7219 on lfr box; if clock is 32.825 mhz; replace ic7120 (ic7220 in stocklist of service manual) (4822 209 31061; s87c652-sn40). | ||
PHILIPS | FL1.6 | Total inoperative, leds blinking, error 99 | Check and replace if necessary c2504 and/or 2505 (2kv hrr) on the large signal panel. replace by a 3kv15 hr-r capacitor if possible: 820pf 4822 126 13152 1nf 4822 126 13153 1,2nf 4822 126 13154 1,5nf 4822 126 13155 1,8nf 4822 126 13156 2, | ||
PHILIPS | FL1.6 | Ticking sound left channel. spikes on left channel. | Check/replace front-end item 1160 fq816 me/if (4822 210 10409). | ||
PHILIPS | FL1.6 | Ticking noise and line in picture | Transistor 7381 (bc848c; 5322 130 42136) defective when hot. | ||
PHILIPS | FL1.6 | The +141 is about 110v instead of 141v | It is recommended to replace the sops pwb (4822 310 31993). | ||
PHILIPS | FL1.6 | Synchronization, picture disappears | D6703 and t7704 defective on picture tube panel. | ||
PHILIPS | FL1.6 | Squeaking sound. | Check c2520 (470 nf; 4822 121 51528). | ||
PHILIPS | FL1.6 | Squeaking sound. | Check c2520 (470 nf; 4822 121 51528). |