PHILIPS TV Repair: Common Faults and Solutions.
Search: PHILIPS
Results: 14171
Results: 14171
PHILIPS Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
PHILIPS | ANUBIS A | No sound | In perm mute as tr7156 bc848 leaky | ||
PHILIPS | ANUBIS A | No ht regulation - r3551 150r sm overheats & tr7537 bc848c fails | Replace 3 x 36v zeners d6557 -9 & 18v zener d6555. also loptx reqd replacement | ||
PHILIPS | ANUBIS A | Menu settings | Reqs rc8611 remote. select last chan by pressing tv+ or -, press vol/p button on set then press vol on r/c for more than 4 secs. | ||
PHILIPS | ANUBIS A | Dead with whine - psu ok on dummy load | Loptx felt warm - faulty | ||
PHILIPS | ANUBIS A | Dead with squealing nise - ht only 40v | Psu ok on dummy load - scan coils faulty - reqs replacement of crt also | ||
PHILIPS | ANUBIS A | Dead with ht correct | R3444 5k6 feed to line driver overheating as driver tr turned hard on; no lt feed to ic7015 line osc chip tda4504 from lop stage as loptx faulty | ||
PHILIPS | ANUBIS A | Dead ht at only 20v instead of 95v if plug m5 rem | D6555 in 5v supply leaky | ||
PHILIPS | ANUBIS A | Dead apart from whistle | Loptx - tested ok on oz loptx tester | ||
PHILIPS | ANUBIS A | Dead , but11 sc. | Use service kit sbc7021 pt no philips 4822 310 20491 | ||
PHILIPS | ANUBIS A | Dead - ht low at 40v (95v) | Tr7537 sm bc848c error sense tr leaky | ||
PHILIPS | ANUBIS A | Dead - ht being dragged down by lop stage | Resistance of 20r across loptr - loptx faulty at2079/40 -tfhr7488 (cpc) | ||
PHILIPS | ANUBIS A | Bright raster with flyback lines. | Break in print on crt base. | ||
PHILIPS | ANUBIS A | Blank raster no sound osd works signal fed via fro | Unit in external mode check pin 18 ic7015 if high check all jumper leads around scart socket | ||
PHILIPS | AA5AB 21PT165B | Overbright raster, with flyback lines | R3470 8r2 o.c. (safety resistor to 183v supply from l.o.t.) | ||
PHILIPS | AA5AB | Line collapse | 680nf cap in line o/p stage low cap | ||
PHILIPS | AA5 AB | No response to r/c commands | St24c02cp eeprom chip | ||
PHILIPS | AA5 AB | Line o/p tr failure | Dry joints rear connector of scan coils | ||
PHILIPS | AA5 AB | Line collapse then off | C2450 680nf 150v s corr cap | ||
PHILIPS | AA5 AB | Dull pic aft replacement of tda8362 or crt base components | R3470 8r2 safety res in rgb ht supply o/c | ||
PHILIPS | AA5 AB | Dead with leds flashing on/off every 3 secs | Eeprom fault - new st2402a made no difference, neither did lm317t reg which had no o/p - crack in print pin 1 loptx |