Search: PHILIPS
Results: 14169

PHILIPS Repair Guide: Common Issues and Fixes

Brand Model Fault Detailed Problem Solution By
PHILIPSTV PHILIPS GX 1899/78
No weapon power supplyReplace c 2420 c 2411 and c 2418JCARLOSMART
PHILIPS29PT558A
Without sound, but with image.Oxidized track or break near the seletronic ground, at the very beginning of the board. check the three trails.Bridge.lou
PHILIPS29PT658
No sound, but normal image.Oxidized track or break near the seletronic ground, at the very beginning of the board. check the three trails.Make a bridge.lou
PHILIPS29PT554A
Horizontal wind blowerResistor r3448 of 8k2 open.Ademir solânea pb
TV PHILIPS14PT3131
Turns on the image appears but turns off in + or - 05 secondsCapacitor 2503 in the power supply primaryReplace capacitor 2503, in the power supply primary. This capacitor was too small for its function. put a bigger one.caio
TV PHILIPS14PT3131
Turning off in 5 secondsReplace capacitor 2503, in the power supply primary. This capacitor was too small for its function. put a bigger one.caio
PHILIPSFWM416X/78
Like fanhosoReplace without measuring q721fabiusmax
PHILIPS32PFL3403/78
Does not turn on, only the standby LED is on.Eeprom memory (7l23) corrupted.leitemarcellus
PHILIPS14GL1016
Philips tv 14gl1016 defect with normal sound on all channels + nothing appears.C2410 close to the top – verticalONLY replacing the c2410ginaldo silva casa do radio picui pb
PHILIPS29PD860A/78R
A10
When turned on, it goes into protection mode, activating transistor 7440 (prot-up), resistor 3437 open (22kohms)Replace resistor 3437 and check the others that are in series with it.leitemarcellus
PHILIPS29PT9467C
0000
TV without plot, just retraceDiode 402 abl with leakageReplace and resolder the other components of the stage and everything went well-good luck!!!Jhone eletronica
PHILIPS14PT113/78R
Power supply does not adjust and the image oscillatesR3528 de 0r33 3wReplaceEletroClaudio Aguas Belas
PHILIPS40PFL5615D/78
Q552.1L LA
Does not turn on, standby LED does not light, power supply defect5.6v standby power supply schottky diodes short circuited.Replace the diodes with an equivalent (2.0a 60v) that is double internally.leitemarcellus
PHILIPS20GL1045
Turns on, then turns off, with LED flashing6365 diode (6v2), measures good... changeEletronica Staub
PHILIPS29PT4631
Does not turn on standby led off and b+ zero voltage @@@Photocoupler can put the photo 817ELETRONICA ARNI/L.LEAL-SC
PHILIPS14GL1019/78
With audio and without imageWhen I enlarged the screen a little I noticed the drizzle and the OSD, I inserted another blank EEPROM.Changing the eeprom, note: this model just inserts a blank eeprom and the micro programs the data.HIPERELETRONICA SERVICE (MARCELO MARAIAL-PE)
PHILIPSHNS7150T
Monitor turns on and off constantly, button panel does not respondSw4 and sw5 of the button panel boardReplace for new onesgilbertobock
PHILIPS21PT5433/78R
When you turn on the sound it is low, after 3 minutes it returns to normalC=2444 of 470mfReplace and analyze components on the same lineELETRONICA MEDEIROS
PHILIPS29GX1899
Doesn't startR 3424 open c2423 shortReplace r 3424 c 2423 shortELETRONICA MAURI JUNIOR
PHILIPS29PT6456/78
Vertical closed top150r smd resistor connected to the 6458 smd diode the resistor is openReplace and run for the hug.fabiusmax