PHILIPS TV Repair: Common Faults and Solutions.
Search: PHILIPS
Results: 14169
Results: 14169
PHILIPS Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS | 29PT4631 | Relay knocking | Resistor 6r8 that feeds the bc 337 e327 | edezio eletronica | |
| PHILIPS | 14GL1316/78 GR1-VA | TV with dark black screen but with OSD without sound | Defect r 3555 27k and r 3204 10k | Pindinga | |
| PHILIPS | 20 PT3336 | Normal sound without lamp opened scrin only gave retrace line | Ver r 3442 e r 3459 | javan | |
| PHILIPS | 14PT218A | With black band at the bottom of the screen, traces at the top and no sound | First make sure you have inserted the speaker plug into the correct input. If you didn't put it in the wrong entry, it's memory. | MB ELETRONICA | |
| PHILIPS | 42PFL3604 | Does not turn on, red LED | PCI micro short | Pablo | |
| PHILIPS | 14GL1310 GR1.AL | No vertical sync and no audio | Ssa0, shaqqkh | Replace without measuring | Pablo |
| PHILIPS | 25PT5541 | Turns on, white screen, turns off after a few seconds | RGB IC, resistor on 200V line open. | Pablo | |
| PHILIPS | 32PFL3403 42PFL3403 42PFL5403 LC8.1L LA | Blown fuse, won't turn on. | D802 and q801 short | Pablo | |
| PHILIPS | 29GX1899 | Does not tune channels | Absence 33v | R 3292 open 15k | ALEX/FETTER |
| PHILIPS | 29PT4641/78 | White lines at the top of the screen | C2465 100v 10uf | fco | |
| PHILIPS | 32PFL3404/78 | Does not work/noise at power supply | Capacitor cb1 with low capacitance or exhausted | Replace cb1 - 4.7μF/450v | ANTONIO DONIZETI DA CRUZ |
| PHILIPS | 29PT552 | The TV has no color and when you change channels it beeps and the horizontal output burns | Defective memory because when changing channels it changes the horizontal frequency causing the bu1508 to burn | I just replaced the memory and I'm fine | charles cbs |
| TV PHILIPS | 20PT424A/78R L9-2A AA | No sound, it doesn't amplify | Dz 6953 3.3v and ci7953 pay close attention to the end of the sound ci letter, if it is mono it has to be tda7056b, do not put the end a | cunha753 | |
| PHILIPS | FW-380C | The CD doesn't work, it accepts selection for the CD but it is inoperative. Some key lights are off. | Replace of 7404, 7405 and 7406 hfe4094 smd on the panel | joaomvjr | |
| PHILIPS | 21PT9467 | Device after some time on, closes the vertical after about 1 hour | Deflector opening one of the windings beneath the glue. | It was very difficult to recover the deflector. I had to replace it. | marcelo lurahy |
| PHILIPS | 21PT5433/78 | No, it doesn't oscillate. But if you measure the frequency, is it 15.7 kHz? | R 3490 changed. Depending on the changed value, several defects will occur in the horizontal | R3490 3k3 | mecinhor7 |
| PHILIPS | 21PT9467C | I had already changed the band's integrated varicap micro memory, etc., a terrible defect only on channel 13, when it was cold, it was out of tune and then when it warmed up, the image improved, it was a more solved puzzle. | And just remove the disk capacitor from the plate that is close to the 100k micro c828 | Remove c828 from 100k disk | carlos de maranguape1 paulista-p-e |
| PHILIPS | 21PT6456 | With sound without image | R-3442 de 100k , proximo ao flay-back . | Resistor aberto no pino 1 do flyback .... | JOELTON |
| PHILIPS | 14PT3132/78R | Has audio characters and a dark screen | R3442 open abl line | samuel leite | |
| PHILIPS | HPS-2991FS | TV burned out the bu 2520dx so far so good, so I bought another one I put it in its place but it didn't work it just oscillated but didn't produce high voltage, checking all the voltages which were ok after so much inspection I decided to put another one from an old board a bu 1508 then the TV worked | Moral of the story, the bu I bought looked good but was bad internally, so sound's a tip guys, be careful with your bu lol | This email address is being protected from spambots. You need JavaScript enabled to view it. tecnico em governador valadares minas gerais 3330842033 |