Search: Panasonic
Results: 2880

Panasonic Repair Guide: Common Issues and Fixes

Brand Model Fault Detailed Problem Solution By
PANASONIC TC20A04
BT4HA006397
Banner left side of the screenD 558.replace 1n4148Eduardo Leal
PANASONIC TC20A04
BT4HA006397
Dark imageR557Eduardo leal
PANASONICTC-32FS500B
Turns on the LEDs and turns off in 5 seconds. Test the bars with a tester and they are workingLed barsReplace LED bars with new ones.Eletrônica Silva Homs
PANASONICTC-L32C10B
The LED would blink 13 to 14 times, the screen would not light up, the relay would hit, it would turn green again, and it would stay in this loop.24v did not reach the inverter board. it had the main_on(24_on) pulse of 3.3v. analyzing the circuit, including the transistor q881 was activated, but it did not polarize the fet p channel q843 that releases the 24v for the inverter. Making measurements with the multimeter, it showed 300r on top of capacitors c890 and c891 of 10u each. removing them, the c890 was showing resistance of 300r. By replacing it, the TV was resurrected. 05/28/2024Monitor Informática - CGPB
PANASONIC CRTTC29FJ30L
TV turns on, stays on for a few seconds, then turns off and keeps hitting the relayZener diode d1132 shortedSecond scheme is 3.8 v, I put 3.2 it worked normallyDTEC-ELETRONICA-Massapê-ce
PANASONIC MINI SISTEM
AKX660
Bluetooth doesn't workTry to resetAline
PANASONIC TC-L32S20B
Turns on, activates the relay, flashes green several times, and then flashes red 3x.Capacitor at the output of the flat cable connector on the main board, right side, close to a fuse wsound tsound are two capacitorsCapacitor shorted on the right side on the main board, at the output that goes to the displayElison48
PANASONIC TC-L42E30B
Does not turn on, LED flashes 1 timeCapacitor c9524 on the inverter board short (100nf 100v) and open protection fuse on the 24v line of the power supplyEletrônica JJ
PANASONIC TC L32C20B
Panasonic TV turns on with green LED blinking and stops blinking, turns green but does not turn on backlight dark screenPhoto altered coupler pc7701 replace it with a new one it was 100%Altered coupler photo "pc7701" gave good joyneupsx4
PANASONICTC-L42E30B
Does not work or turn on standbyShort on the 12v line and burning the q7504 code tpc8116In my case it was 01 ceramic capacitor shorted on the main board close to the q8100 and q8101 just touch it and run for hugjorge assistencia tênica
PANASONICTC20KL03
Turning itself offCapacitor c519, 33uf,160vReplaceVelk Som
PANASONICTC-L32B6B
Turn on screen LEDs on but no imageDefect 12v power supply missing from display, defect on signal board replace ci, ic5421Ariel Santos
PANASONICTH-50PZ80LB
No standby, 5v present, and 3.3v present on the functions board connector. electrical discharge coming from the hdmi inputRemoved the adv7495b hdmi ic but still has shorted points on the main ic. The TV turned on right away and worked for 3 minutes and didn't turn on again.Solution to replace main board
PANASONICSA-AKX660
Connection failure, or audio failing on bluetooth.Update: https://av.jpn.support.panasonic.com/support/global/cs/audio/download/akx640_660_880/index.html@Heraldo PhDTec
PANASONICTC-L32C5B
Turning off blackoutR7830 r7829. de 470 hm later per 1kEletrónica do gilvan multi service.
PANASONIC32FS500B
No imageLEDs offIt appeared to be burned out LEDs but the defect was two 100μF x 63v capacitors on the main board. After changing the capacitors, the LEDs came onALBERTO INTERTV
PANASONIC TC-L32B6B
TV works normally - when increasing the volume... above 50... TV keeps turning on and off by itself... when decreasing it below 50... TV works normally...The defect was in the power supply.. power supply board..Replace the power supply board..Emerson Ribeiro
PANASONIC NN-GT682
Does not activate magnetron, minutes count normally.Low power supply, d106Replace without measuring d106, μF4002
PANASONICSA-AKX440
Doesn't start. It doesn't even light the panel.Dz1000 diode shorted.I replaced the dz1000 diode (code: b0jcpg000032 schottky barrier) with model sb140 (shottky found in a TV power supply with pfc).R-Tec
PANASONICTC-14A04
TV doesn't turn on, standby LED lights up very weakly.The 5v line on the standby was only 2v, as was the 3.3v line that comes out of the ic1201 regulator and powers the computer.Zener diode d1140 (5.6v 0.5w) shorted, killing the 3.3v line that powers the computer. By replacing this diode, the TV turned on again.Rgs011