Panasonic TV Repair: Common Faults and Solutions.
Search: Panasonic
Results: 2880
Results: 2880
Panasonic Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| PANASONIC | SA-AK110 | No audio - the ci rsn35h2 is fine | Resistor (r503) open | MARCOS ANDRÉ | |
| PANASONIC | NN-SF560WRUK | Display does not light | Cold weld no c-352 | Soldier | LOU |
| PANASONIC | TX-25XD4F EURO 4 | As soon as it turned on, it activated the protection made up of q852 to q855 and relay rl801, that is, q857 was active. | I lifted the r567 (7w 1Ω) and the problem persisted. the problem was in q857 which had an undetectable leak at low voltages, however as the voltage at its emitter reaches around 150 v, this same voltage reaches the collector without causing an overcurrent in r877 | Replacement q857. I replaced it with bf423 which is equivalent to 2sa1018 | PASTOR |
| PANASONIC | TC-20C20 | This TV arrived to me with the following defect, it turned on and then turned off, when I lowered the brightness it worked normally but with low brightness. | After a lot of fighting with the TV, I discovered the defect was a q503 transistor near the flay back, note.. you have to remove it from the board, and everything will be normal, great! | diego lima nova timboteua PA | |
| PANASONIC | TC-21FX30LMON | 3 colored lines running vertically, in the image at the top of the screen. | R407 open 221r very close to the deflector pump connection... | vilenon | |
| PANASONIC | TX28PK20F EURO4H | Image moved to the bottom of the screen, with a pillow effect | Resolder smd components in futurebox | Rodeio2011 | |
| PANASONIC | TX28PK20F EURO4H | High power supply | Defective se140n | Rodeio2011 | |
| PANASONIC | NN-7856BAK | When you press the on button, it turns off immediately and the set time resets | Broken track between pin 4 of CN3 and 10k R39 | Retrace the broken trail | Helio (Eletrosonic) |
| PANASONIC | TC 20A12 | Heats up r 520, r521 changes and turns off | C519, c520 | Replace them all | e matos. eletronica |
| PANASONIC | TC 20A12 | Turns on and then turns off | C519, c520 | Replace them | e matos. eletronica |
| PANASONIC | TC-20C2 | Works normally, but the power supply's primary transformer keeps vibrating strongly | Replace str 50213. | LOU | |
| PANASONIC | TC-20A10 | Activates protection when turned on | X-ray protection | Turns off diode 590 and r592 | This email address is being protected from spambots. You need JavaScript enabled to view it. |
| PANASONIC | TC20C6 | Triggers protection | D544 with leak | ||
| PANASONIC | TC14C6 | Image with drizzle | Cause: c1181 with leak | klein | |
| PANASONIC | 29A11 | Sometimes it doesn't turn on, when it does turn on it works normally | Intermittent horizontal driver transistor | Barter it | WARLEY CESAR |
| PANASONIC | TC21FJ30 JJ | Turns on with 2m turns off | Crazy about prot d511 | Jj | fernado tj maçeio |
| PANASONIC | TC 14C7 | Tuning keeps changing, a.v doesn't come in | R 1166 , ic 601 side open, d 1150,1151 eprom side com, leak. | e matos. eletronica | |
| PANASONIC | TC29A12 | Does not come out on standby | Cristal x001 | Replace the same | eletronicaapolo |
| PANASONIC | TV14G7 | No sound no image. When disconnecting the transcoder PCI the sound appeared and when jamming the video signal the image appeared: the 12v power supply that went to the PCI was giving 7V and also 7V at the Q1052 collector. | C1012 330/18v stewed. | @gepe | |
| PANASONIC | TC2OA9 ? | It only oscillates when you clean pins 27 and 26 of the power | Change microprocessor | edson ou tinho |