Panasonic TV Repair: Common Faults and Solutions.
Search: Panasonic
Results: 2880
Results: 2880
Panasonic Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
PANASONIC | TC-14A12 | Image shifted to the right horizontally with a white "cloud" above | Cause: d558=ma185 shorted. obs. you can put 1n 5061 and it works fine. | Other substitutes: ba157, ba173, bay21, bay46, baw52. good luck everyone. | This email address is being protected from spambots. You need JavaScript enabled to view it. |
PANASONIC | TC20A10 | Does not oscillate | Short vertical | Replace | ELETROCLAUDIOPE AGUAS BELAS |
PANASONIC | TC 20A10 * | With vertical lines turning off in less than 5 seconds. It was changed and after being resolved, it turned on normally with no image and a blue screen appears. | C-452 and c-829 and r-106 amended | Your replace. | eletronica wagner |
PANASONIC | TC-29KL05 | Hits the relay and turns it off (protection) | R556 open | Replaced | Reginaldo WK Eletrônica |
PANASONIC | TC-14A10 | It doesn't turn on even when it's new | D 402 zener 36v | paulinho | |
PANASONIC | TV 14 OU 20 RM10L | Bad image, no contrast | See r 557 and or revise the line | Master Eletronica | |
PANASONIC | TC20RM10L | Blinking LED, power supply with a burning smell, and returning current. | D-810 (ar-s1-50) in short. | Replace with the same one, or with a2-85. | eletronica vinisom e tv |
PANASONIC | PAL20RM | Blinking LED, power supply with a burning smell, and returning current. | D-810 (ar-s1-50) in short. | Replace with the same one, or with a2-85. | eletronica vinisom e tv |
PANASONIC | TC20A12 | Works and stops | I turned off protection (q 605) | Bruno | |
PANASONIC | TC-20RM10L | No audio | Micro burnt | This TV arrived without audio, the customer informed that this happened after a heavy rain, I tested the input to the audio ci with the ociloscope and found no signal, I decided to inject audio at the same point and I had audio in the speakers, ultimately micro burnt, as the signal comes directly from this, I looked for this one which is a tda9540h/n3/2/1916 smd and I couldn't find it, I had the information that the tda9540h/n3/2/1784 is the same, I looked for it and it was easier to find, but expensive in around R$50.00, I couldn't risk it with this price, I looked more and found it for R$13.00 in Rio Grandedo Sul, I ordered a part and replaced it and the TV worked normally | ivan@ |
PANASONIC | TC-20RM10L | No audio | Micro burnt | ivan@ | |
PANASONIC | 20G11 | Turns on normally, then turns off after a few seconds. | R556 ou c823 | Replace | c.edgley |
PANASONIC | TC20A12 | Works and stops | Turns off q 605 (smd) | Bruno | |
PANASONIC | 29FX30L GP41 | Turns on and the image decreases on the sides and +b drops and turns off. | Power supply | Replaced r 833 (4k3), check 831 (6k8) and 830 (220), they are under the w6556 radiator | joaomvjr |
PANASONIC | TC-29KL03 | Swings frame and sometimes beeps horizontally | C 558 100nf abl | Angelo | |
PANASONIC | PVM2023 | Strong buzzing and does not activate. | Check power supply next to vcr | Replace q1001 (fte driver) can be a but11apx, q1002 (pre power supply) can be a bc639 and 18v zener diode d1d15. | OLIBIO-ELETRONICA ESTUDIER F.:51-30512464 |
PANASONIC | TC-20A12 | TV turns off after a few minutes | C-519 33x160 without capacitance on the +b line close to the flaybak | Replace the same | francesco |
PANASONIC | TX-21MD3E EURO2M | With sound, without image, without mat | Transformer t501 code 5270103200 short | Wind transformer and replace fuse f851 | Divercentro |
PANASONIC | TC-14A10 SEM CODIGO | TV doesn't turn on +b with 50v drive oscillates but cuts out | Vertical ci truck 7840 | francesco | |
PANASONIC | TC-14A04 | Turns on and off | Open 560k resistor r556. | Ademir solânea pb |