Panasonic TV Repair: Common Faults and Solutions.
Search: Panasonic
Results: 2880
Results: 2880
Panasonic Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
PANASONIC | EURO2S TX29AD2 | Tripping, red led flashing, relay operating | Fault caused by sound power supply not running and pulling down scl3 data line. replace r2502, r2503 150k on k board | ||
PANASONIC | EURO2S TX29AD1DP | Excessive width with e/w error | Q593 bc547b | ||
PANASONIC | EURO2S TX25AD2DP | Won't go to stby | Q667 bc547b o/c | ||
PANASONIC | EURO2S TX25AD2DP | Trips to stby every 2-3 secs, frame collapse | I601 vdp3108appa1 | ||
PANASONIC | EURO2S TX25AD2DP | No sound, no pic, led pulsing dim-bright | Relay rl6101 (tse10818) faulty, replacement from goodmans 1430 works ok | ||
PANASONIC | EURO2S TX25AD2DP | Dead, no startup | 5v supply to ic1801low because ic1601 an78l05ta faulty (5v regulator) | ||
PANASONIC | EURO2S TX25AD1DP | E/w fault | Q593 bc847b s/c | ||
PANASONIC | EURO2S TX25AD1DP | Dead, tripping | Q651 o/c (part no. tfd312s0f632) | ||
PANASONIC | EURO2S TX25AD1DP | After replacing eeprom set comes on to channel 0 and 'normal' settings will not memorise | Press together 'status' on r/c and 'function' at front of tv. the set will run 'self-test'. switch the set off, then back on and re-tune | ||
PANASONIC | EURO2M TX28MD3 | Blows mains fuse every 2-3 months | Replace ptc 232266296319, also mains lead connector may come loose and arc (part no tsx8e0017) | ||
PANASONIC | EURO2M TX25MD3 | When watching vcr, ghost image of another pic moving across screen, also colour bands. | Customer using fully wired scard lead, thus tv's tuner output is fed back to vcr what modulates video playback picture. remove unused leads in scart cable or use non-fully wired scart cable. | ||
PANASONIC | EURO2M TX25MD3 | Pic gradually fades away, returns when set sw off & on again - sound unaffected | Ic601 vid proc chip vdp3108-app1 | ||
PANASONIC | EURO2M TX25MD3 | No pic, sound ok | No supply to line driver q503, replace r507 3.3r safety (erq14ajw3r3) | ||
PANASONIC | EURO2L TX28LD1 | Stuck in stby | R558 120k o/c in beam limiter circuit off loptx | ||
PANASONIC | EURO2L TX28LD1 | Severe overscan, pic appears upside down | Wrong type of ic451 used, use from panasonic | ||
PANASONIC | EURO2L TX28LD1 | Pic smearing on highlights, going green and magenta at either side of highlight | Replace ic601 vdp3108-29 and set-up video levels and a1 voltage | ||
PANASONIC | EURO2L TX28LD1 | Distorted, displaced chroma | Ic601 vdp3108appa1 | ||
PANASONIC | EURO2L TX25MD1 | Streaks of colour on pic | Replace ic601 vdp3108appa1 | ||
PANASONIC | EURO2L TX25MD1 | Screeching noise | Repace ic2101 msp3410 (can use part no.10372340 for ferguson) | ||
PANASONIC | EURO2L TX25MD1 | Rgb lines at top of picture | D454 (era1502v3) d456 (ma2160blfs) in frame o/p |