Philco TV Repair: Common Faults and Solutions.
Search: Philco
Results: 4741
Results: 4741
Philco Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| PHILCO | PCS2956N - | Tvc works for a while and turns off | Resoldas main plate. | virgilio | |
| PHILCO | PCS2976 | When turning on image with screen effect and turns on protection in 15 seconds. | Very high supply, above 122 v. (measured 157v) | R 919 of 120 k replaced, causing increase in +b, consequent increase in focus and abl voltage (activating protection by the proc.) | OLIBIO |
| PHILCO | PCS 2700 | Intermittent league/slide | Q904 - bf 423 e c 918 10mf sem capac. | OLIBIO | |
| PHILCO | PCS 2700 | Shutter effect | R 610 de 270r | OLIBIO | |
| PHILCO | PCS-2976 | Dead, high supply (170 v) | Replace resistor 917 (2k2) diode 908, d 902 (transistor type) ic 802 (photo-coupler) | Replace these components and the device will function normally again. | WAGGUINHO |
| PHILCO | TP-1454 | Tall and short | D-909 shorted, r-910, r-912 open | Ramiro Lima | |
| PHILCO | 2052N | Without generator, but with normal +b voltage | C-911, c-913, c-942 change all | Ramiro Lima | |
| PHILCO | 1445 | It works normally, but if you turn it off and turn it on, it just keeps drizzling and without characters. | R-144 aberto de 4k7 | Ramiro Lima | |
| PHILCO | 1452 | Without generating, but with all normal voltages at the power supply | D-106 aberto | Ramiro Lima | |
| PHILCO | 1451 | Generates and cuts, and gets the normal +b2 | Changed deflector | Ramiro Lima | |
| PHILCO | PCR-1447 | Generates and cuts at the same time | 10k open r-707 | Ramiro Lima | |
| PHILCO | PCR-1447 | With image and sound, little brightness | 10k open r-714 | Ramiro Lima | |
| PHILCO | PCM-2044 | Without generating, but with the +b, led blinking and killing horizontal oscillator voltage | Micro-m37210m3-709 | Ramiro Lima | |
| PHILCO | PCM-2044 | It works and picks up some channels, sometimes it freezes on just one channel. | R- 113 open 22k | Ramiro Lima | |
| PHILCO | 1443 | Without generates, and without +b. | R-711 open from 6.8r | Ramiro Lima | |
| PHILCO | PCS-2956N | Interference in the image, RF type | C208 | ||
| PHILCO | TP 2052 | Does not tune channels - autoprogramming does not capture channels. | Transistor q201 bad. was open, cutting +b from seletronic | This email address is being protected from spambots. You need JavaScript enabled to view it. | |
| PHILCO | PCS-2700N | Image disappears after a while | Check cable welds to kinescope board, r708, solder on kinescope board | ||
| PHILCO | PCS2976S | Dead | Ss09 | ||
| PHILCO | TPF-2940 | No audio in rf | C401 e c402 |