SAMSUNG TV Repair: Common Faults and Solutions.


AIWA
BEKO
CCE
CINERAL
DAEWOO
FUNAI
GRADIENTE
GRUNDIG
HISENSE
HITACHI
ITT
JVC
LG
MITSUBISHI
PANASONIC
PHILCO
PHILIPS
PIONEER
RCA
SAMSUNG
SANYO
SHARP
SONY
THOMSON
TOSHIBA
VESTEL


Search: SAMSUNG
Results: 3754

SAMSUNG Repair Guide: Common Issues and Fixes

Brand Model Fault Detailed Problem Solution By
SAMSUNG551V
Doesn't startDamaged ic604 (5v regulator)nois
SAMSUNGCN5049V
Vertical retraces even fold the topResistor 304 150hms openpedro.assitel eletronica
SAMSUNGCB-3351AH
P68AM		DeadC307 (100uf 50v) secoNezocas
SAMSUNGCN 3355Z
P 62 SA		Vertical closedR 415 openReplace r 415ELETRÔNICA HEINZ
SAMSUNGCN5066
Normal image with traces across the entire screen.ProfitReplacementThis email address is being protected from spambots. You need JavaScript enabled to view it.(floripasc)
SAMSUNGCN3383
Vertical fexadoR305 open.ReplacementThis email address is being protected from spambots. You need JavaScript enabled to view it.(floripasc)
SAMSUNGCL 21Z58MQ
TV doesn't turn on5v missing on pin 69 of the micronasReplace capacitor c 819 on 6.5v supplyDirso
SAMSUNGCN5038 & 5066
TV has the image warping and the color disappears22/50v capacitor shortedWash or clean the capacitor residue on the chassis and replace c.246 2.2 / 50vVALDO RECIFE
SAMSUNGCL29Z43MQ
Doesn't turn on, there's a pulsating sound in the speakerThis TV had a shorted horizontal bu, it was replaced, the TV had retraction lines and turned off on the RGB tube board, I replaced the TDA6107, it was brokenELETRONICA ARNI-LEOBERTO LEAL /SC
SAMSUNGCN5055Z
Wide dark band at the bottom of the screen, after it heats up, the image opens.C302=2.2mf per50v, no capacity.It was replaced and beauty.Armando da Eletonica só tv
SAMSUNGCB 20S10B
AA41		Pisca st byPhoto broken coupler and dz808 c leak 9.1vJOGAR
SAMSUNGCL 29K40MQ R
C L		TV turns on normally and then turns offIt was resolved by changing the r 413 abreta, okIt worked normally without turning off.JOSÉ BENICIO
SAMSUNGCL-21M6MQ -L
CL-21M6MQ2X/XAZ		The horizontal output burned and the power supply explodedToca cap ey 421 de 552j 1600vThis email address is being protected from spambots. You need JavaScript enabled to view it.
SAMSUNGCL-29M21MQ
Does not turn on, only charges the power supply and does not turn on the stand byDz 810 and dz 819 shorted killing the 5v.renato multitec This email address is being protected from spambots. You need JavaScript enabled to view it.
SAMSUNGCN3355Z
It had +b (125v) but it didn't oscillateCold solderingRessolda q 401 (horizontal)NILTON-AVARÉ-SP
SAMSUNGCL-29M21
It only stays on standby, when it turns on, it goes into protection.Cold solder no but hc801 (reg 5v)Persio(TVCOMPANY)
SAMSUNGLE32S71BX
GSM32SE		Power supply voltages at half their valueIcm801s f9222lReplace icm801s (attention: there are poor quality ics on sale)jose luis calcada
SAMSUNG540N
Takes a while to callCapacitor da power supply 1000uf 25v e o 330uf 25vReplace the sameeletroclaudio aguas belas
SAMSUNGCL-21Z43MQ
Power supply does not oscillateZener diode 803 16 volts next to the ci and the ci itself. Many times only the diode burns, but the one I got had both burnt out, I hope to help someone out there...Alessiano.g.a
SAMSUNG540N
SYNCMASTER		The monitor turns on normally after 10 minutes, only the back light turns off, leaving the screen dark, you can see in the background that it continues to work, turning it off and on again, it works for a short time and turns off again successively.When heating the diodes d104 and d105 they short circuit or change a lot, to test them, remove them from the circuit and heat the terminals with the soldering iron, before they cool down test them on a high scale (x10k) if the leak is greater than the middle of the omimeter scale, replace them, note that these are precision diodes (high-frequency) so try to replace them with original diodes or with similar characteristics.wagguinho