SAMSUNG TV Repair: Common Faults and Solutions.
Search: SAMSUNG
Results: 3754
Results: 3754
SAMSUNG Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
SAMSUNG | CB20H42T KS1A | Tries to start but turns off, no mat | In power supply d805 (+125v b+) shorted | Good power supply fuse | joaquim cunha |
SAMSUNG | CN-5066VB | TV doesn't just start on stand by, when it turns on the LED blinks a few times and goes out and nothing | Ci 301 of the vertical (tda 8356) broken, after the change the TV started but had colored lines in the middle of the screen, I realized that the 45v voltage was low so I changed the r 410 | Replace the vertical ci and r 410 that comes out of the 45v line of the fly back | GEORGE PONTES |
SAMSUNG | DVDP-370 | Drawer doesn't open | Missing 5 vdc pin 8 of the driver | Broken print | Roberto Consertos |
SAMSUNG | MM-L2 | Doesn't read CD, won't focus | Leisure unit potentiometer out of adjustment, adjust the potentiometer to 0.75 (75%) of the maximum value of the resistance of said potentiometer and turn on the unit to see if it can read the CD or not, if it does not, replace the leisure unit (code soh-aau ) | Adjust the laser potentiometer and clean the focusing lens of said unit, if it doesn't work replace the unit with a new one | Joãombs |
SAMSUNG | 29M21MQ | Only staby light when turned on goes into protection and returns to staby | PCI connections | BRUSKE | |
SAMSUNG | CL29Z50MQ | TV turns on but after 10 seconds it turns off | C 803 empty | mauricio | |
SAMSUNG | CN-3383V | Turning off by itself | Replace c305 | This email address is being protected from spambots. You need JavaScript enabled to view it. | |
SAMSUNG | CL-21M6MQ | When the TV was turned on, the +b of the flayback had 178v, the power supply was unregulated | R831 of 123k . measuring 154k and just change it and that's it | This email address is being protected from spambots. You need JavaScript enabled to view it. | |
SAMSUNG | CV 3383 V | Retrace line at the top of the screen | C307 (100-50v) ao do saida vertical | welljackson | |
SAMSUNG | 551V S | Reduced horizontal width. set to 100% does not open fully. | C419 de 2,2nf/1600v | Also check d409 and c420 | WF Eletronica |
SAMSUNG | CL-29K40MQ | With sound, without video and without OSD | Zd903 with leak | Zener de 5,6vts | This email address is being protected from spambots. You need JavaScript enabled to view it. |
SAMSUNG | CN5048V KCT12A | Uncontrolled vrt/horz timings | C246(2.2/50v) connected to pin 53(cag) of ci 201(tda8374a) | Replaced the c246 ok | Clayton |
SAMSUNG | VIDIO CESSETT X45BR | It doesn't turn on, it just turns on the three LEDs | Def. power supply c35 470uf 16v | ELETRONICA ARNI - L. LEAL | |
SAMSUNG | CN-3355Z | Doesn't start | Diode z 130v in short bu hour. in short braid and heating and burning change 0 supply cap c811 470uf 16v | ELETRONICA ARNI- L. LEAL | |
SAMSUNG | CN-3355Z | Doesn't start | Def. 270k r805a1 slot resistor | ELETRONICA ARNI- L. LEAL | |
SAMSUNG | CL-29M21MQ | Only st by, when activating power, goes into protection | Ci hc 801( ka78r05) broken. | ELETRÔNICA ESTUDIER | |
SAMSUNG | CN-3448 | Turn on, there is no video, the sound is normal, enlarge the screen, it brightens only when it is full of horizontal stripes | Troubleshooting the rgb on the tda 6101q tube board | I replaced it and plz | This email address is being protected from spambots. You need JavaScript enabled to view it. |
SAMSUNG | CN-3355 Z | Vertical closed | Changed to r- 451 open | jaironuness | |
SAMSUNG | CB3351X P68SC-M | Always turns on stby | Judg. 02 (2 years 1) | joaquim cunha | |
SAMSUNG | CB3351X P68SC-M-00 | Does not turn on, good fuse | C853 (100uf/160v) rebentado | Causes elevated b+ (214v), | joaquim cunha |