SAMSUNG TV Repair: Common Faults and Solutions.
Search: SAMSUNG
Results: 3754
Results: 3754
SAMSUNG Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| SAMSUNG | UN40H4200 | Stuck at logou, or no image | Https://www.youtube.com/watch?v=fu-vuzoqeio | Claudio Jorge Eckert Junior | |
| SAMSUNG | PL43E400 | Disarm go vs | Ysus in short | Q5018 fgd4536 d5116 sf10a400 q5016 irg7r313 q5014 e q5003 resitor de 15r r5023 | Ives |
| SAMSUNG | CL-21K40MQ | Turn on the high voltage and return st by | Cr404s 681x2kv near the fly | BOSCO | |
| SAMSUNG | UN49K6500AG-CURVA | Doesn't start. The standby LED responds to the remote control by blinking. | The board turns on tcon, but does not light back up and does not generate an image. | Defective eprom. I recorded a new one, 25q. | joaomvjr |
| SAMSUNG | LN26B350F1 | Doesn't start at all | Open mains input fuse and pfc power supply fet in raw qp802s (k8a60da) I put some strong ones in place, in this case I used 10nm60n I also changed the resistor rp820 0.12rx3w in this case I put one of 0.22rx3w | Replace the same ones and go for the hug (if you have it in scrap, it's better because of the quality of the parts) | orlando lott |
| SAMSUNG | LN40C530F1M | Turns on, flashes standby 1 time and returns to standby again | Changing the z1021h regulator makes the power supply 1v2 | joemioalmeida (kinkas eletrônica) | |
| SAMSUNG | UN40EH6030 | Back light on without image | Capacitor cd6 shorted on t-com | In this case it could also be cd5, 7, 8 or others | Mariano |
| SAMSUNG | MX-FS8000 | Inoperative (does not turn on) | Capacitor cm806 na power supply | Tecdudu neves | |
| SAMSUNG | UN55ES6500G | TV doesn't turn on | On the power supply board cs802 /22wf/50v cs805 /47wf/50v both without capacitance and cs810/47pf rusty terminal after replacing the power supply broke the TV turned on everything worked perfectly but if you turn it off the relay keeps knocking and the TV no longer turns on if you remove it From the socket, let the TV cool down, turn it on again, the problem was the Blutooch card, change it and run to hug | jorge assistencia tênica | |
| SAMSUNG | LN32A550 | When turning on the TV, it would turn on normally, a few minutes later, the image would disappear and only the sound would remain. | Cold solder on one of the contacts of the inverter transformer | Cold solder on one of the contacts of the inverter transformer | Eletrônica Cunha Pedrosa |
| SAMSUNG | PL43F4000 | A blinker doesn't turn on | 30nf capacitor | Broken weld... resoldering | Marcos |
| SAMSUNG | UN65MU6100 UN55MU6100 UNXXMU6100 BN41-02568 | Does not turn on, nor stand by LED, subtle leak in c433_ut and capacitors in the region, voltage of 13v with 9.4. ic400_ut with leak/short. | Replace ic400_ut (vpm1rt) | electronicssupplyparts - Gramado/RS | |
| SAMSUNG | UN40J5200 | No image with back light active | Curto capacitor smd cd01 | Defect on the panel tab board tsound are 2 flats on this board, isolate them to see if the defect is on the right or left side circuit CD01 is on the right side | paulo pinho |
| SAMSUNG | PL51F4000 | Grainy image | After changing the smd transistors rjp30h1 (2) the image became grainy. Cause, the transits were fake, bought from ml. I took them from an old board and it was a mess | The fgpf4536 smd also burn out when the rjp 30h1 is shorted | Cabeça |
| SAMSUNG | PL43F4900 | Stop | Shorted transistor (q5009, q5013=3n50) | Position of each transistor, q5028, 5016, 5029=30j127..l)(q5019, q5010=fgd4536)(q5011=smk630)(q5008, q5015=5n50)(q5024, q5025=tmd630) | Cabeça |
| SAMSUNG | UN55F7500AG | Turn on turn off | Slc1013m ci of the LEDs to change. | Sérgio Ribas | |
| SAMSUNG | UN40EH5000G | The backlight turns on but tsound is no image | Capacitor c04 on the tcon board shorted near connector 1 of the flat that goes to the screen. | It shorted several other capacitors and killed several voltages on the board, preventing the display from working. | GDJ |
| SAMSUNG | UN39FH5205 | Does not light up bus | Check/change 47x200v electrolytic next to the bus connector | Replace without measuring. in the test it is ok | oskarala |
| SAMSUNG | UN40K6500 | It turns on smart and then turns off the backlight, but it is still working. | Replacing the main board | Emanuel Aphiletron | |
| SAMSUNG | UN32J4300 | Does not connect to Wi-Fi, when accessing the network menu it returns to the previous mode | Wi-Fi module supply voltage low, it was measuring 3.92v when it was supposed to be 5v | Defective q207, 6-pin ci | Lucas |