Sony TV Repair: Common Faults and Solutions.
Search: Sony
Results: 20067
Results: 20067
Sony Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| SONY | SL5100 | Front panel clock / timer door | I need part number for the door that covers clock/timersettings on front panel. -hq comments: the part number is x-367-500-70. this information is alsocovered in t/n #8418. a fax has been sent to you. | ||
| SONY | CDP200 | Chattering audio | Servicer complaint was chattering audio. the unit alignedcorrectly except for clv pll which would not lock. waveform at tp9 wasnot correct, as was 1/8 wfck (which uses pll output as reference). rv401had little or no control over pll. | ||
| SONY | D5 | Won't play past track 6 or 7 | Unit would not go past track 6 or 7 on discs. | ||
| SONY | XR900 | No part numbers - line out cord | I need the p/n for the following cord. -hq comments: please order p/n 1-557-661-11 (cord with connector)listed in the preliminary manual under accessory. we will issue a s/b. | ||
| SONY | FD40A | Dead, replaced q602 and leaky d602 | Q602 melted because d602 was leaking. fuse not blown. | ||
| SONY | KV2680R | No vert sync and color, replace 9v reg q-204 | Picture keeps on rolling and no color. | ||
| SONY | CFS350 | No audio output | No audio output. | ||
| SONY | SLHF300 | Pinch roller solenoid replacement | Replacement part (identical number) has stop washer onplunger. washer is too large to allow proper installation of motor andgear assembly. | ||
| SONY | SL2400 | Negative picture during c/r | During cue, rev or pause the unit would intermittently producea negative like picture, we found delay line dl-1 to be open. | ||
| SONY | KV2680R | No pix, no sound, leaky c-104 replaced | Unit when turned on would come up with high voltage but nosound, no picture and no control from front panel of any function. foundc104 reading 150Ω on pin 15 of ic105. this capacitor caused no mclock on pin 25 of ic103. | ||
| SONY | CFS5000 | Wrong p/n | No such part number (a-3247-124-a) and cfs-5000 has 2 colors. holder, cassette (gray) x-3321-505-1 holder, cassette (gold) x-3321-505-2 -hq comments: we will issue a s/b. | ||
| SONY | D5 | No power | Unit had no power. | ||
| SONY | CCDV8 | No e to e | No blanking. | ||
| SONY | CCDV8 | No eject | No mode power dc. | ||
| SONY | CCDV8 | Beta scan noise | Beta scan damaged tape. | ||
| SONY | TV520 | Different pinout | Substitute picture tube has different pinout than originalone. kc says that this is a good sub but a bulletin was issued on howto rewire set, i can find no record of it. -hq comments: we will investigate this problem and if necessary, issuea t/n and s/ | ||
| SONY | SPP11 | Noise in handset | Hand set would make all kind of noises. when power was firstturned on, it would dial one digit. | ||
| SONY | SL10 | Noisy special effects in beta ii | Beta ii pause, betascan and beta skipscan is noisy anddifficult to watch. -hq comments: this is normal operation for the sl-10 in beta ii opera-tion. this model does not have the required 1/2h delay line or the jogprocess ic which is used for error fre | ||
| SONY | CFS5000 | Incorrect p/n - band select switch | Part number ordered is also stamped on part received. partordered is two position switch approx. 1 1/2 inches long with 8 pins inmiddle, part received is approx. 2 inches long with 16 pins along entirelength. we think part number in the manual is wrong | ||
| SONY | CCDV8 | Drum was not starting | Drum was not starting. |