Tcl TV Repair: Common Faults and Solutions.
Search: Tcl
Results: 151
Results: 151
Tcl Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
TCL | L49S4900FS | No image | Smd capacitor c37 tcom board shorted | Removed capacitor c37 from the tcom board. check fuse next to the tcom input connector -> how to know which capacitor is shorted. inject 12v voltage, placing it on the fuse and the ground on the board, it will soon heat up | Claudio Eckert |
TCL | L49S4900FS | No image | Smd capacitor c37 tcom board shorted | Removed capacitor c37 from the tcom board. | Claudio Eckert |
TCL OU SEMP | L32S4900S /SEMP TCL 32L2600 | Only stand-by the main board 40-mt56e1-mag2lg can be replaced by 40-mt56e-mah2lg-bz or vise versa | Microprocessor problem | Exchanging it: they are compatible, the brand of the TV will only appear on the TCL screen for Toshiba or Vise Versa | Airton Filgueira |
SEMP TCL TOSHIBA | 32L1800 | Burning LED bus. | Voltage above normal at the backlight power supply output (77.5v). the expected was 72v. | I replaced the values of r795, 796, 797 (0Ω) to 1Ω. next to the u770. correcting previous tip!-->> note: remove r796 then the voltage drops to 72v | EvandoViana |
SEMP TCL TOSHIBA | 32L1800 | Burning LED bus. | Voltage above normal at the backlight power supply output (77.5v). the expected was 72v. | I replaced the values of r795, 796, 797 (0Ω) to 1Ω. next to the u770, the voltage dropped to 71v. good luck! | EvandoViana |
SEMP TCL TOSHIBA | 32L1800 | Burning LED bus. | Voltage above normal at the backlight power supply output (77.5v). the expected was 72v. | I replaced the values of r795, 796, 797 (0Ω) to 1Ω. next to the u770, the voltage dropped to 71v. good luck! | EvandoViana |
SEMP TCL | 32S5300 RTK2841 | Does not activate, nor does the ST BY LED. fuse intact | Measures secondary power supply voltages zero.causes mosfet qr01 - 15t15gh shorted. - ref. 150volts, 11.2 a channel n. | OLIBIO - ELETRONICA ESTUDIER CANOAS RS | |
TCL | L49S | Turn on tsound is audio but no image, turn on the LED bus | Shorted t-con board, open fuse | In my case it was a shorted capacitor! I identified it, replaced it, replaced the fuse and everything went back to normal. | Rodrigo cofferi |
SEMP TCL | L39S3900FS 940047 | Turns on normally but does not work via remote control | On the infra receiver board | C6102 short, remove and run to the crowd. | eletronica medeiros |
TCL | L43S4900FS | When turned on, TCL appears and disappears in 5 seconds, turning off the TV | Checked all voltages 12v, 89 v (LEDs) and tested the LED bus, everything ok, removed the Wi-Fi card and it continues to turn off. | The firmware was updated according to the TCL procedure that comes with the file (.zip), everything resolved. Note: use USB input 1, wait about 5 minutes until the LED on the panel stops blinking, then just turn on the TV and run for a hug. | CDS_DIAS |
TCL | H32B3803 MT31EPA | No sound or no sound when hot (after a while) | Diode d101 a7(baw92), replace with 2 diodes in antiparallel (pay attention to the position) bav21 | zelectronic |