TV Repair: Common Faults and Solutions.
Search:
Results: 87441
Results: 87441
Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
SONY | CDX7540 | Complaint of skipping but unit is dead | Complaint of skipping but unit is dead. found q-414 shortedand badly burned on main pc board. this is the fourth unit i have seenlike this. could this be an installation problem? | ||
SONY | SLHF900 | No part number part of ud assembly | What is part number of the item that number 328 fits into?see page 185 of the service manual. -hq comments: the part number for the ud arm is: 3-691-650-01. | ||
SONY | D66 | No sound on right channel line out | The line out jack (j-301) was defective. the right channelpin on the line out jack was cut too short. this was a new part from kcp. | ||
SONY | KV20EXR10 | At turn-on picture flashes several times, adjust g2 | At turn-on after about 10 seconds the picture flashes on/offseveral times, then stabilizes. | ||
SONY | KV27XBR10 | Dead set, replaced ry-601 ("f" board) | Dead set. power relay coil open. should measure about 255Ω. | ||
SONY | KV27HSR10 | Singing yoke, replaced yoke. see service bulletin 114 | Replaced singing yoke. -hq comments: please refer to tvp service bulletin number 114. newyoke part number is 1-451-275-41. | ||
SONY | STRAV1000 | Speaker protection always on | The speaker protect circuit is always engaged. the problemappears to be related to the power supply. we noted that the schematicshows two separate grounds. in fact there is about 3 volts differencebetween the two. when the two grounds are tied togeth | ||
SONY | EVC8 | Recording color is bad | Unit was recording with no green component (color bar). | ||
SONY | CVM1900 | Very weak vertical hold | Very weak vertical hold and appeared to also have a horizontalsynch problem (another shop replaced ic-501, problem not solved). spenttime checking dc voltages, waveforms around ic-501, checked ok. lookedcarefully at waveform on pin 24 of ic-501, vertic | ||
SONY | CPD1304 | Mistake in s/m "d" board | Service manual shows pin 6 of ic-901 on the d board to beconnected to the 120 volt line. this is not true. there should be noconnection. fuse in the 120 volt line is missing in the s/m. has therebeen a correction issued? -hq comments: tokyo will iss | ||
SONY | KV27XBR60 | "h" board and ic-51 have been changed, see supplement 4 | |||
SONY | KV32XBR65 | H board and ic-51 change, covered in supplement no. 4 | H board and ic-51 have been changed. -hq comments: there has been a change in the h board and with ic-51.service manual supplement number 4 has been issued to cover these changes.h1 board 1-629-621-23ic-51 8-741-100-62 cbx-1618-51 | ||
SONY | KV32HSR10 | Vertical lines in picture, service mode adj "ref" set to 1 | Three to four retrace lines are visible at the top of thescreen. they do not look like ordinary retrace lines, but are of solidred, blue, or green colors. | ||
SONY | KV32XBR65 | Vertical lines in picture, ref mis adj, also check r-517 | Three to four retrace lines are visible at the top of the screen. they do not look like ordinary retrace lines, but are of solid red, blue, or green colors. | ||
SONY | KV27XBR15 | New h board, refer to supplement number 4 | H board and ic-51 have been changed. -hq comments: there has been a change to both the h board, and ic-51.service manual supplement number 4 has been issued to cover thesechanges.h-1 board 1-629-621-23cbx-1618-51 8-741-100-62 ic-51 | ||
SONY | KV32XBR15 | Rgb vertical lines in pix, adj. "ref" in the service mode | Three to four retrace lines are visible at the top of the screen. they do not look like ordinary retrace lines, but are of solid red, blue, or green colors. | ||
SONY | KV32XBR10 | Vertical lines in picture, adjust "ref" | Three to four retrace lines are visible at the top of thescreen. they do not look like ordinary retrace lines, but are of solidred, blue, or green colors. | ||
SONY | KV32XBR15 | H board and ic-51 have been changed, refer supplement # 4 | H board and ic-51 has been change. -hq comments: h board has been changed to the h1 board (1-629-621-23).there has also been a change in the sensor ic, it has been changed to p/n8-741-100-62 (cbx1618-51). please refer to service manual supplement - 4fo | ||
SONY | KV27HSR10 | Horizontal rgb, lines in picture, check r-517 | Three to four retrace lines are visible at the top of the screen. they do not look like ordinary retrace lines, but are of solid red, blue, or green colors. | ||
SONY | KV27XBR65 | Rgb vertical lines top of picture, see tvp sb # 76 | Three to four retrace lines are visible at the top of the screen. they do not look like ordinary retrace lines, but are of solid red, blue, or green colors. |