Search:
Results: 87418

Repair Guide: Common Issues and Fixes

Brand Model Fault Detailed Problem Solution By
SONYSL2410
Intermittent play modeStop or p/b mode about 1/2 to 1 1/2 hrs.
SONYSL2000
Unit will not work on battery powerUnit will not work on battery, but works with tt-2000.
SONYKV1512
Picture dimPicture is dim. does not have full width, horizontal. frequency. runs too high.
SONYKV1920D
Insufficient vertical deflectionCannot get full vertical def. vertical distortion on thetop, about 1/2 foldover.
SONYSL5200
No reel driveNo threading nor unthreading, rew, ff.
SONYSTRVX550
Intermittent outputAudio cuts off intermittently. sp relay kicks off.
SONYKV1356R
Intermittent shut-down, reajusted hold down circuir (r-541)Unit shuts off on ch. 22.
SONYKV2670R
Improper brightness, r-526 and d-508Brightness and screen controls did not work.
SONYSTRVX750
Audio cuts outAfter unit warms up, sp relay kicks off.
SONYKV2681R
Dead, replace t-501 and q-504Unit was dead due to one leg of t501 was shorted to groundwhich in turn took out the h. output transistor.
SONYKV2680R
Raster but no audio/video, ic1109 shorted on "x" boardUnit had raster out, no video nor audio, and r1247 wouldshort out at turn on.
SONYKV25XBR
Marginal failure of ic651 regulator moduleDark pix (customer complained of no video, however video isdiscernable when pix contrast is maximum), 90% raster (horizontal width),audio ok.
SONYPSLX510
Incorrect ass'y numberCould not locate part number for stator assy. found on page27 the assembly is numbered 129. it should be 126. -hq comments: will issue a t/n and s/b.
SONYXRM10
Very low, yet undistorted am band audio levelAudio ok coming out of am ic, but would not pass thru c-60 onam pc board.
SONYCFSF11
No recordPause is engaged before record. indicator lights but recordlinkage is not engaged. the record trigger lever is jarred off recordlever a (see p.10 of the supplement #1). -hq comments: replacement of forward lever is necessary. the problemcomes from th
SONYSL25
No p/b or f/f functionsNo f/f mode at all. would enter rewind mode whenever the p/bmode was entered. the sensor leads resistance would change from 4Ω to20Ω whenever the leads or the pc bd of the sensor was agitated.
SONYKX2501A
All blue raster, retrace lines, very low video level, q1302Crt raster was all blue with faint retrace lines and very lowvideo level. we were unable to reduce the blue level with crt or bright-ness controls. dc voltage checks allowed me to trace problem to a leakytransistor, q1302 on bd board.
SONYKP4600B
No green vertical sweepWith set on, there was no green and display bar (which wasblack), rolling vertically. system looks like a problem in the picturetube area, but found no green vertical sweep. with loss of verticalsweep, there is no horizontal line, because itclue was th
SONYSLHF300
No powerUnit would not power up. replaced ic301 (timer) but ic wouldnot reset, so problem was not resolved.
SONYD5
Blown transistors and ic (sled circuit)Unit was brought in for service due to defective sled motorgears. upon inspection, we discovered that ic508 and q502-505 were burntseverely. the chip transistors disintegrated. ic508 is cracked and brownin color.