MITSUBISHI TV Repair: Common Faults and Solutions.
Search: MITSUBISHI
Results: 1346
Results: 1346
MITSUBISHI Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| MITSUBISHI | TC1418PS | Black lines on the top of the tube and changing vertical feed | Cause none c451 | eletronica shalon | |
| MITSUBISHI | TC2009 | Time it turns on, time it doesn't turn on | C 906 c 908 (power supply) | Krul | |
| MITSUBISHI | TV1499 OU1492 LAV | Slow blinking led | Zener 6.2 at the power supply was leaking | apolo tres coraçoes m.g. | |
| MITSUBISHI | TC2018 | TV without video | An increase in voltage at pin 11 of the micro m52771asp to 3v (normal is 1.1v) | Replace the 10k 503 resistor with a new one. | Ademir solânea pb |
| MITSUBISHI | TC-2018 | Stays on standby | Check ic 251, regulator 7809 with problem | pardalzito | |
| MITSUBISHI | TC 2098 | When turned on, it lights up stand by and tries to oscillate once, then press power and it doesn't work. | You can see that when the LED is plugged into the socket, it lights up weakly and then brightly but nothing. | Disconnect the kinescope pacifier if the tv works replace the trc. | Dé Andrade |
| MITSUBISHI | TC 2098 | Reduced picture, looking like a bad power supply capacitor. | Normal power supply. | Replace horizontal width capacitors, 4.7 and 5.6x1600volts. | Dé Andrade |
| MITSUBISHI | TC 2099 | Does not oscillate power supply, no voltage in the power supply secondary. | TV does not turn on or the standby LED lights up | R 904 of 47k it was open - replaced it and that's it. | José Adriano |
| TV MITSUBISHI | TC 2099 | Tv works normally with lack of horizontal synchronization the image does not work | Change the elect c 705 cap next to the micro | domingos macedo | |
| MITSUBISHI | TC2098 | LED lights up normal power supply does not turn on | R 561 of 10 k open | Roque | |
| MITSUBISHI | TC-2018 | Power supply does not operate. (it is not even on standby) | C 913 aberto (220mf x 25v) | TVCompany | |
| MITSUBISHI | TC-2018PS | No colors | Micro | Replace micro m5277 | joaomvjr |
| MITSUBISHI | TC-2018PS | When cold tune out warping image | Varicap | Varicap resoldering or replacement | |
| MITSUBISHI | TC 2099 | Doesn't start | R900 because of the short in ic 901 also change c 905 and c906 | ||
| MITSUBISHI | TC 2099 | Vertical with bands at top and bottom | C457 | ||
| MITSUBISHI | TC2010 | Normal power supply, but without generating high (oscillate). | T552 (horizontal driver) with open primary coil. | CARLOS MAIA | |
| MITSUBISHI | 2098/99 | Does not turn on / stand by blinking | Check: r661- ic 953 - photocoupler - panel buttons | tyko | |
| MITSUBISHI | TTC-2098 | Reduced frame | Reduced capacitance | C 555,556. | This email address is being protected from spambots. You need JavaScript enabled to view it. |
| MITSUBISHI | TC 2098 | Standby LED flashes and does not turn on | Power supply capacitor c 907 change attention note...do not test on the capacitor as it will give the right capacitance but does not work on the circuit | joão dantas | |
| MITSUBISHI | 2018PS | Keyboard stuck and no characters appear | Exchange of 470mf/16v diode d953 and c956 |