MITSUBISHI TV Repair: Common Faults and Solutions.
Search: MITSUBISHI
Results: 1346
Results: 1346
MITSUBISHI Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| MITSUBISHI | TC-1410 | Vertical slightly open with lines at the top of the screen | R462(22r changed) and c467(100nf ceramic) both connected to pin 5 dp ci451. | Replace the r462 and c467 | jarbas santos |
| MITSUBISHI | TC 2009 | Slipping away from the tune as if it were a cold sore. | Eeprom memory with data interrupted. | I replaced it and it was fine. A hug and a merry Christmas to everyone | This email address is being protected from spambots. You need JavaScript enabled to view it. |
| MITSUBISHI | TC 2910 | It starts with a small dark band at the top of the screen and after it heats up the band increases until it closes the screen, and there is only a horizontal line in the center of the screen. | Capacitor c453=3.300mf por 25v. | It was replaced and it was... ok. | Armando Eletronica Só tv de Olímpia |
| MITSUBISHI | TC2098 | Works for a while and turns off..., all normal voltages... | R 563 ; 180k ,aberto | Trokar ,r563 .180k | dony pinheiro |
| MITSUBISHI | TC 1499 | No horizontal synchronization | Tda 4662 | teceletrik | |
| MITSUBISHI | TC-20A | 115v power supply measuring 100v and noisy | C902 sold out | Replacement | paulo |
| MITSUBISHI | TC2099 | TV stuck in function lock | You must proceed as follows: with the TV turned off, press the (channel +) key, then press the (channel -) key, the television should turn on normally. however, it will still continue with its active function. To deactivate it, go to the menu and look for the lock function and deactivate it. | heliomar | |
| MITSUBISHI | TC2099 | TV stuck in function lock | 1) with the TV turned off, press the channel + button and then the channel - button. the TV will turn on; | heliomar | |
| MITSUBISHI | TC2099 | TV stuck in function lock | Unlocking mitsubishi mod tv. tc-2099 | heliomar | |
| MITSUBISHI | TC 2099 | Poor focus, no visible image appears (blurred tube) | Bad tube socket | Remember that one hand washes the other. | Marcone This email address is being protected from spambots. You need JavaScript enabled to view it. |
| MITSUBISHI | TC1498 | Black stripes passing diagonally across the screen | C-705 | Capacitor replaced near bnmicro c-705 | edivaldo |
| MITSUBISHI | TC-2098 | Does not oscillate the primary power supply | R-904 = 47k x 1/2w | FERNANDO S | |
| MITSUBISHI | TC2098 | Closed vertical. | With the TV unplugged, we placed an external power supply on the +b 25volt line that polarizes the vertical, in series with a 40W lamp. The lamp turned on at full brightness. IC 451 was shorted. | Replaced ic451 ta8403k, and the r465 1r opened due to the short in ic 451, the TV returned to normal. | Lucas40 |
| MITSUBISHI | ñ SEI | This TV just has a blinking LED and it doesn't turn on | A 16v 470uf capacitor | It was replaced and it's all good. Friends, I'm sorry I don't know the model of this TV. | This email address is being protected from spambots. You need JavaScript enabled to view it. |
| MITSUBISHI | TC-2099 | All white screen with background lines | 24c2 memory replacement | 24c2 memory replacement resolved | H.IM ELETRONICA |
| MITSUBISHI | 2098 | (image out of focus) | Bad picture tube socket | Marcone | |
| MITSUBISHI | TC2098 | No video with horizontal black stripes. | Trimpot vr654=220r cracked, green cathode regulator. | Just replaced it and adjusted it, it was ok. | Armando da Eletronica Só Tv |
| MITSUBISHI | TC-2098 | Low power supply does not oscillate | 3r3 power supply resistor in place of the 0.33r resistor | Put the correct resistor 0.33r | Eletroclaudio Aguas Belas PE |
| MITSUBISHI | TC-2009 | Turns off after a few minutes | D714 5v6 changed | Replace | paulo maceio/al |
| MITSUBISHI | TC 1418PS | It doesn't turn on, it just stays on standby | R 571 and c567 causing heating of r571 |