PHILCO TV Repair: Common Faults and Solutions.
Search: PHILCO
Results: 4741
Results: 4741
PHILCO Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
PHILCO | PCR-2049 | Turns on turns off after a while | Cold solder not resistor r 705 | ||
PHILCO | PC-2037 | Turns on turns off after a while | Rahaa D is more deserving | ||
PHILCO | PCM-1444 | Turn on then turn off | C719 - 10/250v | ||
PHILCO | PCM 2051 | Turns everything on without any problems, when you turn it off, it doesn't turn back on | Capacitor cap708 e cap-709. | ||
PHILCO | TPF2130 | LED on, power supply ok but not turning on | Pin 1 of ic 905 was at 0v | C918 1000/16v defective, replace | jasvan souza |
PHILCO | TV PH21US | Standby LED is on but won't turn on | Transistor v502 | And just replace | ELETRONICA AUTO TREVO |
PHILCO | PCS-2952N | Blinking led | C711 sem capacitance | ||
PHILCO | 14PHD | Philco ph14d tv by varicape with image without sound av with sound | Mormal image without sound via external antenna | Swap memory | patricio |
PHILCO | TV PH14C | Doesn't start | C438 shorted | Replace the same | jk eletrica |
PHILCO | TPS-2064 | Dead power supply | Resistor r 911 open | Replace the same value 2.2m | TIAGO.ELETRO |
PHILCO | PCS-2976S | Does not start, LED is off | Smd 936 | robson | |
PHILCO | TPF2940 | Standby LED flashing, the TV does not oscillate and goes out. | It was the two capacitors c1701 and c 1703=5k6 with low capacitance, I replaced them and the TV worked normally. | ELETRÔNICA MELO BOA VIAGEM -CEARA | |
PHILCO | PCM2051 | Takes time to call | Change c708 and 709 | joosias | |
PHILCO | PH21MSS | Cushion effect image stretched to one side | Diodo 454 (d454) proximo ao fly back | Bruno nicacio | |
PHILCO | TP-2052 | Does not turn on stantbay led blinking and with +b voltage varying @@@ | C913=1ufx100v | Help yourself leave your tip | ELETRONICA ARNI / L. LEAL-SC |
PHILCO | TPF2121F | Remote doesn't work | Leak between the sensor terminals, change it, or, in my case, scrape off the epoxy a little between the terminals and also between the contacts and the ground and also change the two 10 uf capacitors that are connected to it | ||
PHILCO | TP1453 | Vertical a little closed | Service mode | Adjust | Mauro Mascarenha - Parazinho Ceara |
PHILCO | PCM2046 | Turns off after a while. | Ic701 e c720. | R-TEC EletrĂ´nica | |
PHILCO | PHILCO PH21B | There are 2 defects, 1 turns on after 1 min + or - darkens and turns off 2 closes a little horizontally with retraction | V502 ou o c2383 | MARCIORV | |
PHILCO | TV-PH21C | Low power supply, LED does not turn on | Q881 changed | JOELTON |