Search: PHILIPS
Results: 14169

PHILIPS Repair Guide: Common Issues and Fixes

Brand Model Fault Detailed Problem Solution By
PHILIPS29PT5642/78
Power supply wouldn't breakAn smd capacitor with leakage in the power supply primaryTrade for another 2532 oklucie santos sp sãopaulo
PHILIPS20 PF 5121
S LC 04C 11
Turns on and tsound is no sound, image or brightnessTr( bc 636 ) place( bd 140) position 7936ELETRONICA CB ALVES
PHILIPS20 PF 5121
S LC 04C 11
Turns on and tsound is no sound, image or brightnessTr( bc 636 ) place( bd 140) position 7936ALVES
PHILIPS21PT9467S
Lack of width or cushionQ303 done replaceTip/ any defect that appears on this chassis first rewrite the eepromvaldir.éThis email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPS21PT9467/78
Fly with bubblesPower supply with 116v q302 d5032 bu2527ax was used, replaced with 4.7/250v c411 not shown in the diagram, fly bsc 29-3807f was used bras alfa another brand does not adjust the convergence well, not even through the setup.BRUSKE
PHILIPS29PT4631
With a stripe from top to bottomR3493 6r8 1wReplaceEletroClaudio Aguas Belas
PHILIPS32PW8608
EM2E AA
Faulty east/west (ew) circuitR3483 1k smd next to photocoupler 7483Pingo
PHILIPS21PT5433/7BR
374121
Screen a little small at the topI don't knowmarcio
PHILIPSPT519A
Red screen and then turns offThe screen turns red and within a few seconds it turns offjair f. dos Santos
PHILIPS14PT3131/78
Place with ten minutes off47 r open resistor 3403maurocelso
PHILIPSTODOS QUE BDS NA SAIDA VERTICAL
Only half of the top or bottom imageR3446 sup. r3445 inf.This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPS20PT4331
Does not include audio and videoEnter service mode (062596+menu) go to option and then to 0p5 enter the number 072 and exit by pressing the menu key and as soon as you exit, turn off the TV in the standy bay to recordEnter service mode (062596+menu) go to option and then to op5 enter the number 072 and exit service mode using the menu key turn off the device so that the replace is recorded in the standy bay and turn it on againJulio Cesar
PHILIPS21PT9467
Vertical, with thick strokes and closed about five cm at the bottom and top.Electrolytic capacitors, c-315 and c-316, both 1000ufx25v. replace them, it's ok.Cláudio Ribeiro, TECNOSAT ELETRÔNICA E INFORMÁTICA, Jataí-Go, This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPS29GX1898/78
Tall, vertical fountain burning!!!2512 capacitor with leak on the power supply plate!!Replace "immediately" quickly and run for a hug.TV TECNICA BRACEL
PHILIPS14GL1019
Vertical half closed giving linesChange the capacitors of the vertical resolder tda 8361 and around it change the green wire that goes to the +12 kinescope PCI to +8vWARLEY CESAR
PHILIPS21PT9467C
SK4.1L CA
Turning off as soon as the image appearsZd303 with leakReplaceeletronicaoeste
PHILIPS29PT5642
L04U
It doesn't turn on, only the red LED is on!T7406Put bu908 or 508ÁdrianChapadãodoCéu
PHILIPS29PT9467S/78
With sound without image, without high voltage beeping loudlyTransformer and lines switchThis email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPS20PT122A
LED is on but does not turn on.C2551 e r34? no pino do +9 do flybackÁdrianChapadãodoCéu
PHILIPS20GL1044
Does not oscillate horizontally and makes a noise at the power supplyCause: 22k r3501 openklein