PHILIPS TV Repair: Common Faults and Solutions.
Search: PHILIPS
Results: 14171
Results: 14171
PHILIPS Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS | 20PT3336/78 | Normal OSD, dark screen and sound on the channels | R 3459 and r 3442 open (both 100k) | ELETRONICA ESTUDIER | |
| PHILIPS | 14PT1556 S L01.2E AA | No image. Tsound is no brightness/contrast control, adjusting voltage doesn't help either. | Tsound is no information eht. resistance 3431 at output 8 of the tr.linhas (ehtinfo) burned out. | Raúl Faustino | |
| PHILIPS | 29GX1895 ANUBIS | The image keeps shaking, tsound are times when it turns on normally, but if you turn it off and on again, the same defect appears (reduced frame, OSD repeated on the screen) | Diode 6199 bzx79-c5v6 on the side of the subwoofer | Check the bc548 next, and also the tip42c | ANDRE |
| PHILIPS | 14PT3336 | It has a power supply but it oscillates and goes out | R 3445 open | miro eletronica | |
| PHILIPS | FW-C505 | No sound, exit ci ok | Ic 7501= tda7468d smd, pins 14 and 15 must have 4.8v if it is low check this clk and data line | BRUSKE | |
| PHILIPS | 20PT 3331/78 | Vertical lines with interference at the top of the screen | Changed the c- 2460 68 k/ 100 volts | jaironuness | |
| PHILIPS | 29PT554A L9 | Image stretching to the left, tuning with low signal | The defect was because the power supply was low, I changed the position from the l5550 to the l5576, no power supply output, it was at 130v, I changed it to 140v, the TV was beautiful | Reversing the position of the l 5550 p l 5576 tv looks great | marcos melo[ CASCAVEL CE ] |
| PHILIPS | 20PT3331/78 | Vertical closed | Changed the 10/250 volt c- 2465 | jaironuness | |
| PHILIPS | 20GL 1045 | Luminance- obs: missing 180 voltsna r-3700 of 470 hms. | Trcar r-3550- 3,3 hms | jaironuness | |
| PHILIPS | 21PT1353/00 L 6.2 | Difficulty tuning, no color and sound | Adjustable coils (5100) | Adjust but replace | J.CUNHA |
| PHILIPS | 14PT1352/00 L 6.1 | Out of tune | Adjustable coils (5100) | Replace with new | J.CUNHA |
| PHILIPS | 29PT4641/78 | Vertical only opens the bottom part of the screen. | Replace diodo ( d 6457 smd ) | dony eletronika | |
| PHILIPS | 14PT3005 L03.2L AA | Upper line is protected. screen | C2460 devalued 0.068 | Replace c2460 r 3446 1 homs | ELECTROFRIO |
| PHILIPS | 14PT3005/44 L03.2L AA | 3 upper vertical stripes (r-b-g). screen | C 2460 0.068 | Replace c2460 | ELECTROFRIO |
| PHILIPS PLASMA | 42PF7320 | Dead | Chap. c 8059 and c 8060 replace the two | DEBIQUE | |
| PHILIPS | 21PT5437/78 | Dark screen with normal osd | Open resistor | R3442 120k was placed 100k | NELSON |
| PHILIPS | 21PT5437/78 | Dark screen with normal osd | R3442 | NELSON | |
| PHILIPS | 21PT9467/78 *** | Remote control and keyboards do not obey (message in the left corner of the factory screen) | Data loss | Ic-101 eepron 24c08 replace e pronto. | jose wagner |
| PHILIPS | 29PT5642 L04U AA | When turning on stand by the power supply keeps pulsing and does not start horizontally. | Leaky coupler photo | antonio | |
| PHILIPS | 29PT4631 | Turns on and off after a few seconds | Replace the two bc's 327 and 337 with bd135 and bd136 | And the note dies | AdrianChapadão |