PHILIPS TV Repair: Common Faults and Solutions.
Search: PHILIPS
Results: 14170
Results: 14170
PHILIPS Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS | 29PT5642/78 | Image with retrace at the top. | Capacitor 2465 (10mf x 100v) | Persio | |
| PHILIPS | 28PW5324/01 A8.0E AA | Doesn't start | Cond in mat 2633 (152k/2kv) short | Good power supply fuse | JOAQUIM CUNHA |
| PHILIPS | 21PT8467/78 | Vertical closed with a horizontal stripe and turns off after 3sg | Resistor (3445) 1r open | letwister | |
| PHILIPS | FW-C505 | I'm sound | I had the 3.15 amp left output protection fuse burnt out. device.it only outputs sound on one channel if the good output is on the left side.in other words, on the ci7301, otherwise it does not output sound on one channel. | In short, I inverted the output from the 7302 to the 7301 and replaced the output that was on the 7301 with a new one because it was shorted from pin12 to pin11, in this specific case it cannot measure on this pin. | This email address is being protected from spambots. You need JavaScript enabled to view it. |
| PHILIPS | FWC-507 | I'm sound | Ci 7403 replacing pin 10 with 9 has the same function | eletronica alsat | |
| PHILIPS | 16GL1031 | Green screen with retrace line | Após checar ic 997, ic900, s925, d365, d945, ts360, kt923, c921, ts943 | I replaced the micro tmp47c434-r308 and the TV started working again | Marcio |
| PHILIPS | 16GL1031 | When turned on, the normal image appeared for about 3 seconds, then the screen turned green with a retrace line | Image tube replacement | Marcio | |
| PHILIPS | 21PT5433 L03LS1 | No audio | Oops with changed data | Op1-000,op2-215,op3-001,op4-226,op5-082,op6-080 e op7-066 | MAXWELL ELETRONICA |
| PHILIPS | DVP642K | Inoperative only on stand by | Q 301 short | Replace transistor | DEBIQUE |
| PHILIPS | 14PT240S | Acting protection | Cold welding on vertical outlet | After resolving the same, the TV returned to normal | sergio |
| PHILIPS | 29PT658A L01.1LAA | It turns off after a few minutes, sometimes it turns off as soon as it has just been turned on. | I changed q7461, and nothing, I changed c2455 with no improvement, I noticed that when the TV was off the air "without antenna", it didn't turn off, only when 10 minutes had passed and the message appeared on the screen that the TV would be turned off, if you change the channels without stopping it also wouldn't turn off, so I decided to make small adjustments to the 'vg2' screen, after a few attempts the TV stopped and turned off, returning to work normally. | This email address is being protected from spambots. You need JavaScript enabled to view it. | |
| PHILIPS | 20PT222A ANUBIS | Vertical closed at the bottom | Ic 7401 / c2463 / c2414 / c2443 / ic 7620 | Replace the ci if it doesn't solve the problem, check the capacitors or eprom | This email address is being protected from spambots. You need JavaScript enabled to view it. |
| PHILIPS | 21GX1666/789 ANUBIS | Blinking LED off | High power supply caused the device to block | Adjustment of the power supply through its module and connecting pins 1 and 20 of the ic7600 to unlock code ff, f8 | rrsva |
| PHILIPS | 29PT4635/78 | When I turned on the TV it kept chirping constantly. | It's easy for the bu to burn out, I just changed it and it was stuck as a precaution, change the horizontal capacitors | This email address is being protected from spambots. You need JavaScript enabled to view it. | |
| PHILIPS | 29PT5642 /78 L04 | Colored lines and does not open the vertical, then protects | Check d 6457 smd short | Master | |
| PHILIPS | 29PT5642 | Vertical open open about 15cm with a sharp line right in the center and at the top and bottom of the opening it formed a sine wave with colored lines on both sides in red. green, blue. | Defective deflector detected on the bottom of the coil with I couldn't find it for sale, I opened it and I fixed the wire that was broken and the TV started working normally again. | Rivaldo Lira | |
| PHILIPS | 21PT6456 | Screen closed without sound | Memory deconfigures | Configure or replace for another | EVALDO GOMES |
| PHILIPS | 14PT418A/78R | Turning off and when held on and with green and yellow arrows in the image. | Kinescope | Changing the kinescope | ARISTEU |
| PHILIPS | 20PT324A | Inoperative led off | Mp 08 / 116 | Replacing it with the original serves as a fuse | EVALDO GOMES |
| PHILIPS | 20GL1045 | Vertical burned | Queima ic pos. 7410 (tda3653/bq) | Diode pos. 6565 (BYD33G) and POS1565 fuse (630mA) | jfmendes |