PHILIPS TV Repair: Common Faults and Solutions.
Search: PHILIPS
Results: 14173
Results: 14173
PHILIPS Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS | 32PFL3403 | Doesn't start | Remove c922 on the power supply board | See other defects on page 24 | itan |
| PHILIPS | 20GL1045 | Strong whistle only in STBY, when activated CR turns on and works normally. | Voltages were all normal at the power supply, I suspected the capacitors, but they were all good | Replace power supply chopper transformer | ELETRÔNICA ESTUDIER - CANOAS RS. |
| PHILIPS | FW-C507 | Cd spins twice and doesn't read | 4r7 at r.3835 | Just replaced it and it was ok | Fábio Andrade |
| PHILIPS | FWM396 | Low outputs don't work | He growled indignantly | Replace | VITALTEC |
| PHILIPS | 14PT414/A | Device does not work, there is no +b in the power supply secondary, transistor and ci are good. | Open 22 r resistor, position, 3525, biases the gate of the power supply transistor. Replace it, it's ok. | TECNOSAT ELETRÔNICA E INFORMÁTICA, JATAÍ-GO, This email address is being protected from spambots. You need JavaScript enabled to view it. | |
| PHILIPS | FWM779 | Device turns on and off after a few seconds. If you turn it on with the voltage selector switch to 220v on the 127v network, the radio works. | Voltage regulators 7500 and 7504 | Resolder the terminals. | EDSON DE SOUZA AGUIAR |
| PHILIPS | FWC-507 | No sound with everything working | Voltage on pin 12 of the output above 25v, transistor 7304 (bdw94) shorted | Changing transistor 7304 (bdw94), sometimes the fet 7309 (stp60ne06) also causes this | bakaninha |
| PHILIPS | FW-C507 | No sound with everything working | Voltage on pin 12 of the output above 25v, transistor 7304 (bdw94) shorted | Changing transistor 7304 (bdw94), sometimes fet 7309 (stp60ne06) also causes this. | bakaninha |
| PHILIPS | 29PT9467 | Does not turn on and/or turns on with a whistle and/or noise in the horizontal position, possibly the sh is shorted | Check short in fly secondary, probably vertical IC tda 4865aj can use tda 4863aj | Master Eletronica | |
| PHILIPS | 170S | Monitor turns on, shows a red screen and then turns off | Backlight lamps (test with the inverter power supply) | The faulty light bulbs were replaced and the monitor started working again. | Gilnei |
| PHILIPS | 21PT5435 | Turning off | C2492-c2461-c2440 | C2492-c2461-c2440 | ELETRONICA MAURI JUNIOR |
| PHILIPS | 21PT5433 | Turning off by itself | Swap c2492 - c2461-c2440 | C2492- c2461-c2440 | This email address is being protected from spambots. You need JavaScript enabled to view it. |
| PHILIPS | FW-780/19 | Noise in channel r with sound at low volume. | Capacitor smd 2602 | Replace capacitor | DEBIQUE |
| PHILIPS | 21PT9467C SK4.1L | When image appears, turns off or turns off before the image appears | Faulty micro tda9373ps/n3/a | Replacelo | antonio nobrega (patos pb) |
| SOM PHILIPS | FWC-270/19 FWC270/19 | No sound comes out, CD doesn't spin, it doesn't open | Measure the voltages for the motors see if the 12 volts are missing see reg 7214 the 25 volts may be missing | Oh and go for the hug | cunha753 |
| PHILIPS | TPF2130 | LED does not turn on | C 918 | ELETRONICA MAURI JUNIOR | |
| PHILIPS | 29PT4635/78 | Just a hum in the fountain | Bu4508dx shorted. | I replaced it with a bu 2527dx and it didn't start, it was c 2455 sold out, replace it too... | pfa |
| PHILIPS | 14PT3331 | Did not adjust the focus | Flay | After changing the tube socket, I touched the tube and nothing resolved it, I decided to replace the flayback and it was said, I ran for a hug. | |
| PHILIPS | 21PT4331 L03.1L | Sound gradually increases when you turn on the device | Capacitor in position c2444 changed | jedvaldo | |
| PHILIPS | 20GL1345 | Vertical shrunken; oscillating horizontally very softly; horizontally shrunken, 4 fingers to the side | Q7205 ... cold welding. |