PHILIPS TV Repair: Common Faults and Solutions.


AIWA
BEKO
CCE
CINERAL
DAEWOO
FUNAI
GRADIENTE
GRUNDIG
HISENSE
HITACHI
ITT
JVC
LG
MITSUBISHI
PANASONIC
PHILCO
PHILIPS
PIONEER
RCA
SAMSUNG
SANYO
SHARP
SONY
THOMSON
TOSHIBA
VESTEL


Search: PHILIPS
Results: 14174

PHILIPS Repair Guide: Common Issues and Fixes

Brand Model Fault Detailed Problem Solution By
PHILIPSFL2.16
Vertical black lines in picture.Supply 141v various. replace sops-pcb (4822 310 31993).
PHILIPSFL2.16
Various faults can be observed.Check the earth connection from the ssp: connect earth tuner with earth line output transformer (lsp) to find-out whether the problem is solved. check connectors l02 and s02 pins 1,2 (sometimes only 7 wires are used in the connector)
PHILIPSFL2.16
Unstable picture, horizontal jitter.Check/replace r3405 on the lsp. (4822 051 10303 for 50 hz sets; 4822 051 10333 for 100 hz sets).
PHILIPSFL2.16
Tuning does not functionResistor r3240 on lsp in v-tuning wire broken.
PHILIPSFL2.16
Totally inoperative. power supply on hardware protection.Check the east/west protection, t7541 and t7540.
PHILIPSFL2.16
Totally inoperative. only red led on.Hardware protection. check t7441(bc847c) and t7440 (bc848c) on lsp. east/west protection.
PHILIPSFL2.16
Totally inoperative. only red led on.Check t7504 on lsp (on4673b; 4822 130 62934).
PHILIPSFL2.16
Totally inoperative. no eht voltage.Check d6536 (byw29f; 4822 130 80982).
PHILIPSFL2.16
Totally inoperative. hardware protection; error 99.Check ic7001 (tda1521q; 4822 209 63913).
PHILIPSFL2.16
Totally inoperative. hardware protection vertical deflection.Check ic7450 (tda3654q/n3; 4822 209 73308).
PHILIPSFL2.16
Totally inoperative. hardware protection is active (error 99).Check ic7001 (tda1521q; 4822 209 73311).
PHILIPSFL2.16
Totally inoperative. error99.Check lot 5555 (4822 140 10443).
PHILIPSFL2.16
Totally inoperative. eht voltage o.k.Check +13v. if too low, check ic7551 (lm358n; 4822 209 70672).
PHILIPSFL2.16
Totally inoperative.Micro sops does not start? check r3249 (220kΩ; 4822 116 52258).
PHILIPSFL2.16
Totally inoperative only stand-by led burns.Check t7506 (on4673 c; 4822 209 63912)
PHILIPSFL2.16
Total inoperative, leds blinking, error 99Check and replace if necessary c2504 and/or 2505 (2kv hrr) on the large signal panel. replace by a 3kv15 hr-r capacitor if possible: 820pf 4822 126 13152 1nf 4822 126 13153 1,2nf 4822 126 13154 1,5nf 4822 126 13155 1,8nf 4822 126 13156 2,
PHILIPSFL2.16
Ticking noise and line in pictureTransistor 7381 (bc848c; 5322 130 42136) defective when hot.
PHILIPSFL2.16
Synchronization, picture disappearsD6703 and t7704 defective on picture tube panel.
PHILIPSFL2.16
Supply switch-off sometimesCheck the +5 stand-by. this voltage has to be 5.5v and may not vary. when the voltage drops below 5.2v the set switches-off. cure: check d6266 for leackage (bzx79/f6v8; 4822 130 34278) or check t7268 for leackage (bd943f; 4822 130 62742). the 5.5v is meas
PHILIPSFL2.16
Supply +5v too low, black horizontal bar in picture. bad sync.Check/replace ic7551 (lm358n; 4822 209 70672)