PHILIPS TV Repair: Common Faults and Solutions.
Search: PHILIPS
Results: 14174
Results: 14174
PHILIPS Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
PHILIPS | FL2.16 | Repeated light-up of the standby-led after switching-off from standby. | Change the following positions on the lsp: position 3250 from 47Ω into 62Ω (4822 116 52198) position 6251 from llz-c5v6 into llz-c7v5 (4822 130 80906) remarks :introduced in production in week 9418. | ||
PHILIPS | FL2.16 | Repair information | Repair information ------------------ in case of one of the line transistors t7504 or t7506 is defective, it is necessary to replace both transistors. order number 4822 130 62934 (2x on4673). | ||
PHILIPS | FL2.16 | Red/green/bleu flyback-lines in upperside of the picture. | Check whether voltage frame flyback (pin 5 ic7450) is o.k. if voltage is too low: replace d6451. | ||
PHILIPS | FL2.16 | Range of picture height adjustment too small. | To increase the range of the picture height adjustment change the following components on the large signal panel: - change position 3422 from 1m3 into 1m2 (4822 116 81223). - change position 3423 from 1m1 into 820k (4822 116 52305). | ||
PHILIPS | FL2.16 | Protection activated due to no +5v from lot. | Check ic7551, lm 358n (4822 209 71825). if ic7551 has to be replaced, it is recommended: 1) for production code ag00-09 add diode bzx79-c18 (4822 130 31024) between 9240 and pin 8 of position 7551, with cathode to pin 8 of ic7551. 2) for production | ||
PHILIPS | FL2.16 | Poor colors, no light in picture | Check ic7207 (sda9205; 4822 209 31056). | ||
PHILIPS | FL2.16 | Pip picture not in order. | Check r3345 (4822 111 41424) in pip unit, check ic7755 (4822 209 63423). | ||
PHILIPS | FL2.16 | Picture very noisy. | Check tuner fq 916 me/bl. | ||
PHILIPS | FL2.16 | Picture twists from top | Voltage of pin 8-ic7450 (tda3654q) on the lsp has raised to ca. 20 v. check diode 6451 (bzx79/c5v6; 4822 130 80954). | ||
PHILIPS | FL2.16 | Picture twists from top | Voltage of pin 8-ic7450 (tda3654q) on the lsp has raised to ca. 20 v. check diode 6451 (bzx79/c3v6; 5322 130 34834 or bzx79/c10; 4822 130 61219) | ||
PHILIPS | FL2.16 | Picture ok after some time | Ic7207 (sda9205-2; 4822 209 31056) defective when set is cold. | ||
PHILIPS | FL2.16 | Picture often dark | Check ic7201 in high end-box (saa9042p/a; 4822 209 31851) | ||
PHILIPS | FL2.16 | Picture gives black horizontal stripes, also on rgb | Ic72027 sda9205-2 lfr box defective (4822 209 31056). | ||
PHILIPS | FL2.16 | Picture disappears shortly after 30" or control does not function. | When hot, 13,5 mhz clock stops working; change the value of r3123 to 1k2. | ||
PHILIPS | FL2.16 | Picture disappears for 10-15 minutes and comes back again | Check transistor t7704 (bc856b) (4822 130 60373) on crt panel | ||
PHILIPS | FL2.16 | Picture disappears (fly back lines), on stereo and dual leds blink | Check ic7430 (tda4680). when tda4680 is too hot there is no picture (4822 209 31592). | ||
PHILIPS | FL2.16 | Overview of sops repair kits | Overview of sops repair kits ---------------------------- fl1.0 ag00 upto ag03 4822 310 20492 fl1.0 ag04 and higher 4822 310 31921 fl1.1 25" and 28" 4822 310 31919 fl1.1 33" 4822 310 31932 fl1.2 4822 310 31932 fl1.6 | ||
PHILIPS | FL2.16 | Only red led is on. hardware protection. | Check e/w protection t7540, t7541 (bc547c; 5322 130 42755) and t7542 (bc857c; 5322 130 42756). | ||
PHILIPS | FL2.16 | Only green led is on. | +5v and +13v supply a little low (+4,4v and 11,2v) check ic7551 (4822 209 70672) and/or d6551 (4822 130 80954). | ||
PHILIPS | FL2.16 | Noise on high volume | Perform the following modifications on the ssp: add on position 3618 4,7nf (4822 122 31784) add on position 3619 jumper (4822 051 10008) connected in series from 2604/4610 to earth. change position 4610 into 1kΩ (4822 051 10102) |