PHILIPS TV Repair: Common Faults and Solutions.
Search: PHILIPS
Results: 14171
Results: 14171
PHILIPS Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
PHILIPS | 37TR126 | Codenumber information | The codenumber for the spacer between on/off switch and the knob (pos 3) is 4822 402 10702. | ||
PHILIPS | 37TR126 | Codenumber correction for deck-up (ic7410) | The codenumber for the deckprocessor was wrong in the first service manual (4822 726 15451). in service information tvcr96-01 and in the new manual the correct codenumber is given. the codenumber for the deck-up for sets with non-turbo drive is: 4822 | ||
PHILIPS | 37TR126 | Codenumber correction | The codenumber of pos. 1701 (tuner) for 14 inch sets with iec input is 4822 210 10691 (uv916s). | ||
PHILIPS | 37TR125/38 | Codenumber information | A new software version (ptcp2-7) is available for the control up (ic 7801). service codenumber is 4822 209 15271. this new version is only used in the following sets: 14pv263/01, 14pv162/01, 14pv162/05, 14pv162/07, 14pv163/05, 14pv163/05h, 14pv263/01 | ||
PHILIPS | 37TR125 | Key set | The key set assy has been codified for all b-range tvcr's. this will allow to change the keys without having to change the complete frame. servicenr. 4822 410 11076. key set for: 37tr120/01/08 - 37tr126/03/38 - 37tr125/38n - 37tvb10/39n. | ||
PHILIPS | 37TR120 | Key set | The key set assy has been codified for all b-range tvcr's. this will allow to change the keys without having to change the complete frame. servicenr. 4822 410 11076. key set for: 37tr120/01/08 - 37tr126/03/38 - 37tr125/38n - 37tvb10/39n. | ||
PHILIPS | 34PT4873 | Mono-carrier pcb-layout of l9.1a | For the above mentioned 21" sets the mono-carrier pcb-layout of l9.1a is introduced to increase the audio power and the way the sdm and the sam is entered is changed. they also have a new side av & headphone panel (e1). the 21pt3952 and 21pt3962 are t | ||
PHILIPS | 34PT4822 | Mono-carrier pcb-layout of l9.1a | For the above mentioned 21" sets the mono-carrier pcb-layout of l9.1a is introduced to increase the audio power and the way the sdm and the sam is entered is changed. they also have a new side av & headphone panel (e1). the 21pt3952 and 21pt3962 are t | ||
PHILIPS | 32W6332/05 | No sound | Tda2616 audio o/p ic & wickman fuse o/c | ||
PHILIPS | 32PW9765 | Pumping effect (horizontaly) of the picture | Pumping effect (horizontaly) of the picture during picture changes from low to high luminance implement a high voltage bleeder in the set on the following way: modifications on the large signal panel: change position c2448 into 10nf (4822 121 41857) | ||
PHILIPS | 32PW9763/05 MD2.25E | St/by only with led flashing | Main micro on control board pin 53 stuck hi due to d6227 zener 3v3 sm o/c. for more info see tv mag nov 2001 | ||
PHILIPS | 32PW9611/58 | Green led comes on at sw on briefly then reverts to red led (st/by) with no 140v at +a | Full wave bridge rects all s/c & safety res 2r7 15w. the chopper mosfet, with strange markings was also s/c type :g239-1hex fitted a irf pc 50 rated at 11amp. in lieu | ||
PHILIPS | 32PW9544/05M | Dead with flashing led | St/by relay - can swap this one with degauss one for test purposes pt no 4822 280 10375 | ||
PHILIPS | 32PW9525 | Pumping effect (horizontaly) of the picture | Pumping effect (horizontaly) of the picture during picture changes from low to high luminance implement a high voltage bleeder in the set on the following way: modifications on the large signal panel: change position c2448 into 10nf (4822 121 41857) | ||
PHILIPS | 32PW6515/05 SA10E | Hum from front speaker | Remove link 9710 & connect link from 9710 (c2702 end) to link 9278 | ||
PHILIPS | 32PW6332 | Service mode adjustments | Short pins s42 & s43 on signals board (upright board on l). now have various options available | ||
PHILIPS | 32PW6332 | No sound | Enter service mode & check option ni (nicam) - should be "y" (yes) next to it | ||
PHILIPS | 32PW6005/05 SA10E | St/by only | Resolder smd tda8885, it is located on the sub-board next to the tuner.(runs very hot) | ||
PHILIPS | 32PW6005 | Set inoperative and ptc defective. | Check and replace if necessary position 3912 on the large signal panel by 4822 116 10105 iris code : m11x | ||
PHILIPS | 320 MONO | No picture. | Bad 07, Takad. |