Search: PHILIPS
Results: 14171

PHILIPS Repair Guide: Common Issues and Fixes

Brand Model Fault Detailed Problem Solution By
PHILIPS2B
Protection circuit active (set hiccups)Remove connector m17, +140 v present check c 2609 (8,2 nf; 4822 121 40249)
PHILIPS2B
Poor reproduction of copy protected vhs tapesPoor reproduction of copy protected vhs tapes --------------------------------------------- some instances have occurred where vcr reproduction of copy protected vhs tapes has been adversely affected by the anti copy signals recorded in the sync period. i
PHILIPS2B
Poor copy protected video tape pb.Mod.
PHILIPS2B
Poor and distorted sound; sound ok via scartCheck/replace ic7102 (u2830b; 4822 209 73756) on stereo decoder (item 1100)
PHILIPS2B
Picture brightness too high; contrast not adjustableVoltage pin 19 ic 7300 > 8 v check/replace d 6490 (bav 21; 4822 130 34189)
PHILIPS2B
Picture and sound disappears sometimesCheck and replace ic 7830 (mab8461p/w155; 4822 209 73465) see service information ct88-34
PHILIPS2B
Pic blanked out6 x 33kΩ resistors, 2 in series in each color circuit on thetube-board to be different. if just 1 of them different from the rest, the tda goes in blanking and remains that way.....replace them all!
PHILIPS2B
Page header suppressionPage header suppression ----------------------- since the bbc changed the ceefax format, receivers with fastext will display the page header continuously when the set is in subtitle mode (page 888). the problem is only observed on bbc recorded programmes
PHILIPS2B
Only uhf tuning (option changed)Replace ic 7925 by st24c02cp (4822 209 62098) and connect a zenerdiode bzx79/c5v6; 4822 130 34173) from both pin 5 and pin 6 of ic 7925 to earth (anodes to earth). align the service option and picture adjustments.
PHILIPS2B
No sound. ok via scartCheck and replace if necessary c2179, 330uf/16v.
PHILIPS2B
No sound, picture ok (voltage on pin 5, 7 ic 7220 present)Replace ic 7220 (tda 1521q/n2; 4822 209 73311). also check soldering-points of sops-transformer (t5663)
PHILIPS2B
No sound, picture ok (sound ok via scart)Check ic 7103 (tda 8405; 4822 209 70934)
PHILIPS2B
No sound with reception of mono transmitters.Check and replace if necessary ic7102 (u2830b; 4822 209 73756) on the stereo decoder
PHILIPS2B
No reception of vhf-channels.Check the option code of the tuner: press simultaneously the keys on the tv "store open" and "saturation+", then switch on the set. on the display you will see the option code and this can be changed with the "c/p+" or "c/p-" key. store with the "store e
PHILIPS2B
No picture, sound ok (voltage on pin 14 of ic 7550 smaller then 2v)Check ic 7550 (tda 8370/v2; 4822 209 70178) and check ic 7570 (tda 3654q; 4822 209 83351)
PHILIPS2B
No picture, sound ok (narrow line when increasing g2 voltage)Ic 7550 (tda8370) is defective. possibly resistor 3535 (10Ω) is disconnected.
PHILIPS2B
No picture from cold picture appears slowly from bC2571 100uf 25v in field cct
PHILIPS2B
Hum on standby, not in normal operationReplace d 6690 (bzv 85/c5v1; 4822 130 31456)
PHILIPS2B
Hum during switchingRemove c 2199 (1,5 uf) on stereodecoder
PHILIPS2B
Frontend fe618q/256 in repair procedureFrontend fe618q/256 in repair procedure --------------------------------------- to avoid a shortage of the fe618q/256 (4822 212 22455) in the future, this frontend is put in the repair procedure (repair only). this means that no new frontends will be deli