PHILIPS TV Repair: Common Faults and Solutions.
Search: PHILIPS
Results: 14168
Results: 14168
PHILIPS Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
PHILIPS | 29PT752A | Pip. does not turn on, protecting | 13 | ||
PHILIPS | 21PT230 | without audio | Eeprom, reprogram or replace | ||
PHILIPS | 14PT100G/78R | Just sprinkles | R3009 (180Ω) aberto | ||
PHILIPS | 28PW858 | Stand-by after 1 hour on | Ssb board rewelding | ||
PHILIPS | 20PT220A | LED blinking non-stop | Non-micro cold welding | ||
PHILIPS | 29GX858 | Dead | Elect. 4.7uf circ standing plate. oscillator.. | Elect. 4.7μF circ standing plate. oscillator. | |
PHILIPS | 14GR1222/87R | Does not light | Transistor c3795b saida horizontal | ||
PHILIPS | 20GL1045/78R | Acting in tune | |||
PHILIPS | 29PT554A | Inoperative, you can only hear clicks in the speaker. | Replace blue c2550 cap 471 which is shorted. Note: there are no voltages on the power supply secondary. | ||
PHILIPS | 20CN4469 | When switching on, the indication f1 appears on the display. | |||
PHILIPS | 14GL1316 | Does not tune channels; with normal tuning voltage and characters. | After changing the varicap without success, I checked the t7100 [band switching] and found that it was leaking. After changing it, the TV started working normally again. | ||
PHILIPS | 20GL 1043 | Check resistor 3321, it usually opens easily and then diode 6340, 15v zener with leak | |||
PHILIPS | 20PT 120A / 78 | Stand by LED is on, when the remote is activated it reacts by flashing and stays on again. voltage +b normal. | Troque fly back | ||
PHILIPS | VR799 | It doesn't start, only the clock appears and a line on the side, it's in the lock key | Hold down the power key for 10 sec on the remote | ||
PHILIPS | 20CT6055 | Just sprinkles | R103 | ||
PHILIPS | 20GL | Sometimes it called, sometimes it didn't. | Replace the flyback and the horizontal output. The fly winding causes a short and the horizontal output is damaged. | ||
PHILIPS | 7CM5279 | Clear screen with retrace lines | R3570 (0,68 r) | ||
PHILIPS | 4CM5299 | Image ok at 640x480 but shifts to the right at 800x600 | Replace c2505 3.3 uf by 4.7 uf. located not pine 10 of ic7502 (hef4538 mode detector) | ||
PHILIPS | 4CM5299 | Image too wide | Check bd677 | ||
PHILIPS | 3CM9609 | Dead | R3121 (270 k 1 w) |