PHILIPS TV Repair: Common Faults and Solutions.

Search: PHILIPS
Results: 14169

PHILIPS Repair Guide: Common Issues and Fixes

Brand	Model	Fault	Detailed Problem	Solution	By
PHILIPS	29PT5645		Cause: resistor 3532 open resistor 3538 open ci ta1620 shorted diode 6536 shorted		klein
PHILIPS	29PT6456	Left side dark stripe	See chap. ceramic 2486 27nf		pardalzito
PHILIPS	14GL1019	No image, dark screen with sound. increasing adjust. screen shows the retrace lines, but without image.	Electrolytic 100uf 25v next to the vertical (tda3653b)	Just replace.	Manoel (Noca)
TV PHILIPS	PT100G-78	Tv scratch in the horizontal direction about two fingers wide with image	Replace o ci tda3560		This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPS	14PT110A/78R	It turned on and in a few moments it turned off, heating everything up.	47/160 v capacitor 2448 burst	Replace it and run for the hug!!!	manoel bonfim
PHILIPS	20PT3336 L03.6L	Without image or negative image, but has normal characters and sound	Resistor r3442 100k aberto	You can also use another one in the same line as vtsupply
PHILIPS	21PT9467	It takes time to turn on, when it turns on as soon as the image appears it turns off - protection	Fly, socket, vertical capacitors of the +b power supply, zd 303 were replaced	Damaged micro, pin 36 needs to have 1.7 vdc, it read 5.6vdc, a 330r resistor was placed from pin 36 to ground and the TV started working again	EDGAR THIZ
PHILIPS E MAGNAVOX	20PT OU MT2131	Oscillating very weakly, looking like a photocoupler, but what about the 5563 resistor?	He fell asleep	He fell asleep	Leilson e eletronica expresso
PHILIPS	21PT9467C	With sound without video	D610, open on the +45v line horizontal oscillator	Replace	Elias Alves (Eletrônica Modelo Jaicós)
PHILIPS	21PT5435/78	Turns on the wire for 1 to 3 seconds and turns off, in which case it goes into protection	If the tube is Samsung, change the tube if it is not, tap the screen		3 em 1
PHILIPS	26PFL3404	Power supply does not turn on	R903 10k aberto		Moura
PHILIPS	20PT528	TV turns on and comes on with a dark screen and turns off giving a bright light on the screen	Vertical output to be shorted, in my case mine was shorted from pin 2 to pin 3, tda9302h has to have h at the end ok	It was just a matter of changing it and the TV went blank	This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPS	20PT528	TV turns on and comes with an all blue screen and no video retrace lines	In the tube socket tsound are 3 18 k resistors, one of them was burned out, I just changed it and the TV came back with an image file	As a precaution, check the other 2 18k resistors as they may be faulty	This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPS	20PT528	TV turns on and comes with an all blue screen and no video retrace lines	In the socket tsound are 3 18 k resistors, one of them was burnt, I just changed it and the TV came back with an image file	As a precaution, check the other 2 18k resistors as they may be faulty	This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPS	28PW6515 A10 E	Does not work with remote control	R3004 burned		cwuam
PHILIPS	PW 6515 A10 E	Image but no sound, sound comes out on phones	T7711 smd shorted bc857b		cwuam
PHILIPS	FWM570/19	It lights up on stand-by when starting, starts ringing and goes off, returning to stand-by, insisting Sometimes it works for a while and goes into protection.	Replace transistor 7506 (bc 847) on the over plate.	7506 bc 847	WAGGUINHO
PHILIPS	14GL1019	Bright spot in the center of the screen when it turns off.	Wow!		Henderson(hndrsn)
PHILIPS	16GL1330 GR1-AL	Green screen with retrace	Ic900 (tmp47c434n-3408)
PHILIPS	40PFL5606D	Fuse blown, shorted to board	Q602,d602 shorted		jefferson