Search: Panasonic
Results: 2880

Panasonic Repair Guide: Common Issues and Fixes

Brand Model Fault Detailed Problem Solution By
PANASONICTC-L42E5BG
League has sound without image all blue screenImage appears and disappears, it is all blue Bad display driver, I changed the displayDefect resolvedAndre
PANASONICTC-L42E5BG
Does not turn on, green LED flashesI checked the power supply, it's ok, I checked the main board, the voltages are fluctuating, ci usb2512b smd short, I removed it from its place, I turned on the TV, it worked, I put a new one in its placeDefect resolvedAndre
PANASONICTC-L42E5BG
Not working, does not turn on standbyPower supply makes a little tick tick noise, if you release the signal board it stops the noise.Smd capacitor on the remote sensor board, the largest, closest to the sensorClaudio Técnico - Ademir Eletronica - Surubim PE
PANASONICSA-AKX14
Doesn't startC5805, c5808, d5801, d5802 and d5803 with cold welding.Remove these components, test, resolder and run for the hug.Vander CDs de Quixadá CE
PANASONICTV 29A11
Does not turn on power supply +b normal standby led onMake a resoldering of the secondary power supplyEletronicaArni-SC
PANASONICTC-L24X5B
TV doesn't even turn onCapacitors c9110 and c9114I replaced the two capacitors and the TV stopped working.Naguinho
PANASONIC TC-14RM12L
TV with low soundR257 56kR257 replaced, just replace and that's it.David jr.
PANASONICLC-L32G11B
Didn't tune in to any channelAn attempt was made to reset but even so, when searching for channel tuning, I couldn't find any, testing the voltages on the varicap, apparently all normal, removing the board to see what the underside was like, I found some lumpy stains.The cake stains were removed with isopropyl alcohol, problem solved, the channels were tuned again.Strutz
PANASONICTC-L32B6B
No image, just audio for a few seconds and turns off.Back light with short LEDs and one open.I lowered the circuit current. I removed the inverter resistors r258, r257, r256. the measurements were 66.8v and 305ma, with back light at 74%, for 63v and 192ma.Eletrônica R-Tec
PANASONICSA AKX600
Doesn't startRectifier diode 36m5 shorted next to coil 330.Resolved.
PANASONICTC-L42U30B
TV turns on and after approximately 30 minutes it turns offTransistor q817 was measuring 2.5v at the base and 10v at the emitter and collectorPower supply diode d840 with leakageADRIANO
PANASONICTC-L32C5B
Turns on after 1 min. goes into protection and turns offBaby, baby 0 (470 r cada). Na black bklighaReplace each resistor to 1k, and check if tsound is a problem with a CCFL lamp.EvandoViana
PANASONICSA-AKX18
Insert usb b doesn't do anything elseAnti-flag firmwareDownload the new one from the panasonic website easily record on a pendrive with less than 32bg turn on the device with the power screen pressed for a few seconds, "reading" will appear on the display, release the button wait until it says "success" ready, unplug it and turn it on again "this solution is on several websites but they all charge the sun shines for everyone tsound is service don't be a rat"Jrezende
PANASONICTC-L39EL6B
Turns on and then turns off.Left speaker shorted.Replace the left speaker that was shorted.Pedrinho
PANASONICTC 29KL04
Horizontal closed with white line in the middle of the screenC 563 / 394j = 390nfReplaceEletrônica Mauro Mascarenha - Parazinho Ceara - Tel : (88)981422821
PANASONICTC-L32U30B
Turns on and then turns offCold solder on the backlight transformer to resolder the entire backlight part of the power supplyGabriel Elias
PANASONICTC20RM10L
Turning off, power supply alternating when changing the image, sometimes the image would stretch and sometimes it would become narrow, and it would turn off, normal power supply 140v, then it would stay 130Change strw 6554 regulator, I put the strw 6556 in perfect conditionDJ PITUKA
PANASONICTC20A04
Blue screen when connecting antenna becomes dark with characters and soundR 557 of 95.3 kReplaceEletrônica Mauro Mascarenha - Parazinho Ceara - Tel : (88)981422821
PANASONICTC14A12
Turns on and off, the LED flashes,Remove r643, to see the real defect, it was the lack of 180v on the grid, defect r555, 2r, and d552 openDJ PITUKA
PANASONICTC14A12
Turns on and off, and the LED keeps flashingPhotocoupler d 807 r 631 360k protection q 401 e r 401 r 520 e r 521 r 864 changed or... remove the r 643 from the protection and that's itDJ PITUKA