Search: Panasonic
Results: 2891

Panasonic Repair Guide: Common Issues and Fixes

Brand Model Fault Detailed Problem Solution By
PANASONICTC-L42U30B
KM11
TV won't turn on without stand-byDouble diode d806 with leakage.The diode with minimal leakage but sμFficient to activate the ovp protection circuit.eletrofepar
PANASONICTC14RM15
GL1
Does not turn on LED blinks activates protection raises protection turns on with half screenSee open 2k7 resistor 405paulo antena
PANASONICTC-40C400B
TV with sound and no image LED bar onCapacitor (cd13) shorted on the LCD boardRemove the sameiNOVA ELETRONICA
PANASONICSA-AKX880
Not callingThe wire of the box is chewedRenata
PANASONIC21FX32L
Constantly turns on and offWas replaced d1132 zener 5.4v shortedJosé delta line
PANASONICTC-L42S20B
Red LED flashing 7xShort circuit on inverter boardReplace switching transistors (fdd8447l)TVPAULO
PANASONIC TC-21FX30L
Turns on normally after 10 minutes turns offC818=1/50v e c842=10/50vELETRÔNICA CENTER
PANASONICTC-32AS600B
TV doesn't turn on, or turns off by itself, or sometimes doesn't turn on and freezes.Defect in the function keyboard PCI. pci is double sided, and the power button track was shorted to gnd. Loosen all components and test track impedance at x10.Isolate the track close to the connector and close to the touch switch, and make a jumper with a very thin wire.rafaelmoraes99
PANASONICTC-32AS600B
TV doesn't turn on, or turns off by itself, or sometimes doesn't turn on at all.SMD touch key on the keyboard has poor functions, causing the TV to have intermittent defects. In my case it was the power key stuck closed, causing the TV to not turn on and remain frozen.Changing bad touch keys.rafaelmoraes99
PANASONICTC-L42U30B
No image lamps light up12v was missing on the tcomCeramic smd short main board without position number but next to tcom a15 flat connectoriran alves dos santos
PANASONICTC-21FX30L
MXT
Doesn't startStandby and turn offChanging the transistor q850ELETRONICA SALES.NATAL RN
PANASONICTC-P50UT50B
Turns on and then turns off, red LED flashes 12 timesAccording to the service manual, 12 blinks is a defect in the audio amplifierReplace IC audio amplifier position IC4900 code BD5452AMUVshermanflima
PANASONICTC-40C400B
It would turn on, then the image would flash about 2-3 times, the TV would disarm and the red standby LED would blink onceI thought it was the LED, I replaced the bar, the problem continued, I checked the SMD fet on the power supply near the LED output, tsound was a bad cold solder, I resoldered it and it worked normally againLucas
PANASONICTC-L32B6B
Turns on the LEDs works and turns off flashes red lightAltered bus with some LEDs burned out or shortedReplace the LEDs or complete busVelkDj
PANASONICSA-AK36
3.3v voltage oscillating between 1 volts is 3.3 voltsDiode d10 on the FR103 power supply boardReplace d10 diodejosé everaldo dos santos ribeiro
PANASONICTC-L39EL6B
Does not turn on, without stb.Leaky capacitor on the main board close to IC 8704.Jadson G Nascimento
PANASONICTC-L42ET5B
Turns on BL twice, then goes into protection and the red LED flashes. 1 timeUsually bulbs, but after changing, the defect persistedChanging protection resistors on one of the LED power channels, against overvoltage, on the inverter PCI, 2 x 684 and 1x 563, a leak would raise this voltage, tsoundfore triggering the protection.davi.sls
PANASONICTC-24U400
Doesn't startTV doesn't turn on, power supply without 5vZener diode with pass d7307--- 7.5voltsoskarala
PANASONICTC-21FX32L
Blue screen when connecting antenna becomes dark with characters and soundRakh D Sakh, AkReplaceEletrônica Mauro Mascarenha - Parazinho Ceara - Tel : (88)981422821
PANASONICTC 21FX32L
With sound characters and no image or no contrastRakh D Sakh, AkReplaceEletrônica Mauro Mascarenha - Parazinho Ceara - Tel : (88)981422821