SEMP TV Repair: Common Faults and Solutions.
Search: SEMP
Results: 2828
Results: 2828
SEMP Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| SEMP | TV2934 | Making noise on the str and pad | C607 from power supply | Replace power supply c607 | wellington |
| SEMP | TV 1030 U17 | Does not tune channels | Dz 312 (10v) secondary power supply 9v | Dz 312 curto 10v | wellington |
| SEMP | U17 | Black stripe on right and left sides | 6n8 capacitor | Beto Eletronica Acrelandia AC | |
| SEMP TOSHIBA | TV2134 SKY | This TV arrived at the workshop with a very funny defect, it started normally as if it would work but then cut out | Loss of capacitance of a capacitor (c634 cap 47uf 160v) | Replace do cap c634 cap 47μF 160v | Ozenildo |
| SEMP | TV1490 U14 | LED on but not turning on | Cold soldering on r416 and r417 | Resolder the resistors | julio |
| SEMP | TV 2134 BSL SK11 | I got this TV like this, it would turn on and before anything appeared it would continually turn off and forget about it. When I turned on the screen I noticed that the screen was just rich in the middle of the screen without reaching the sides. | I checked primary and secondary power supply sh and sv. everything ok. After a week of almost giving up I found an open inductor at position 200, this inductor takes 5v to pin 22 of the tda processor. I played it, the TV was great. Thanks, a hug clebson vale de pirabas/ parÁ | Clebson Vale | |
| SEMP TOSHIBA | TV2091KA | Horizontal output shorted | Substituir capacitor c419(45uf/50v) | Recommendation: check the quality of the horizontal output transistor, use darlington bu808dfx | Luir |
| SEMP | TV-2134 | Oscillates and turns off, killing all secondary tension. I almost gave up on this TV and was amazed when I discovered what it was. | L306 | Replace l306 | This email address is being protected from spambots. You need JavaScript enabled to view it. |
| SEMP TOSHIBA | LC3245F, LC4045F, LC4245F | Locking keyboard and remote control | Check the value of the smd resistor in position r602, itsΩic resistance must not be less than 4k7, if it is below this value the track that goes to r580 must be open. | ||
| SEMP TOSHIBA | LC4245W | Enable Audio out output when using hdmi connection | 1) remove the smd resistors from positions r346 and r347. 2) replace the 33k smd resistors in positions r214 and r217 with 330k smd resistors 3) add jumpers from the positive terminal of capacitors c211 and c212 to the Audio out connector terminal, as detailed below. | technical bulletin | |
| SEMP TOSHIBA | LC3245W LC4245W | Low sound introduces noise in the audio | Isolate the PCI from the chassis, removing the SMD jumpers that connect the PCI ground to the chassis ground. in the position of the m806 screw, next to the tuner tsound is no jumper, so isolate the fixing screw with the chassis by placing a paper or plastic washer on the top and another on the bottom. | ||
| SEMP TOSHIBA | LC1510Z | Washed canvas | U27/d40 c370 e c69 | amram | |
| SEMP TOSHIBA | TV2122 | Vertical closed | Check diode 885 | Sequeira | |
| SEMP TOSHIBA | TS167 TS207 | Jagged image with flyback noise | Check c408 (10/16v) | Sequeira | |
| SEMP TOSHIBA | TS167 TS207 | Power supply low, screen increases, voltage drops | Check r613 | Sequeira | |
| SEMP TOSHIBA | TV2070 | Image closed on the sides | Check q803 | Sequeira | |
| SEMP TOSHIBA | TV1480 TV2080 | No characters | Check ra98(47k) | Sequeira | |
| SEMP TOSHIBA | TV1480 TV2080 | Sound only at maximum volume | Check ra17 (3k3) | Sequeira | |
| SEMP TOSHIBA | TV2092 U16 | Horizontal transistor burns out or heats up too much | Verificar c419 (47/50v) | Sequeira | |
| SEMP TOSHIBA | TVC160 | Image with scratches at the top | Replace c310 (4,7/160v) | Sequeira |