SONY TV Repair: Common Faults and Solutions.
Search: SONY
Results: 20066
Results: 20066
SONY Repair Guide: Common Issues and Fixes
| Brand | Model | Fault | Detailed Problem | Solution | By |
|---|---|---|---|---|---|
| SONY | PSX7 | Replacement motor will not mount | During troubleshooting, we found that replacement motor(a-460-801-9a) would not mount properly. dimensions of motor shaft andspindle were different. | ||
| SONY | PSX6 | Open cap c205 | After several minutes of operation platter slows down and getsprogressively slower. | ||
| SONY | PST25 | Spacers to remove | Platter scrapes on side opposite tonearm. | ||
| SONY | PS212 | Leaky q3 | Turntable speed is too fast. | ||
| SONY | PS20F | Replacing stylus | The stylus of the moving coil cartridge for the ps-20f isreplaceable. the part number is nd206. | ||
| SONY | MDR3L2 | Wires break | The distributor (norcal) has reported to me several brokenwires on these units. the wires break at the plug end. | ||
| SONY | M200 | Spring out of location | Switch sw3 did not move to off position when stop buttonengaged. problem was spring (3-561-626-00) was off at stud end, not slideend. | ||
| SONY | M101 | Short on mic. | No sound. | ||
| SONY | ICFS5W | Solder connection | Sound would come on loud then become low and distorted. | ||
| SONY | ICFC805W | Defective ic and r602 | No light in display tube. low b+ to ic. | ||
| SONY | ICFC805W | Bridge solder connections on pcb | Clock running 10 seconds fast per minute. | ||
| SONY | ICFC511W | Defective clock | The time the alarm is set for moves with the rest of theclock. it will not stay at the time set. | ||
| SONY | ICFC411W | Incorrect part number - reversed | Incorrect part number - reversed. | ||
| SONY | ICFC410W | Defective d4 | Continuous hum as if bad filter capacitor caused by shorteddiode, d4 replaced d4. | ||
| SONY | ICFC33W | Display too bright | Customer complains that display is too bright and wants toknow if his unit can be modified to correct his complaint. -hq comments: safety regulations do not permit changing the value of thecomponent that controls lamp brightness. | ||
| SONY | ICFC15W | Defective power transformer | Dead. check for hum in radio when repaired. | ||
| SONY | ICFC15W | Defective ic - mm5387n | Hour numbers jumped from 4 to 7, 8 back to 7 instead of 4, 5,6, 7. | ||
| SONY | ICFC15W | Short in pcb | No clock read out. voltage on grid too low. | ||
| SONY | ICFC11W | Poor contact | No alarm, switch was not making proper contact. | ||
| SONY | ICFC11W | Poor connection in switch | Cannot set alarm. |