Search:
Results: 87441

Repair Guide: Common Issues and Fixes

Brand Model Fault Detailed Problem Solution By
SONYTCWR720
Rattling noise from tape mechanism - will not go into playRattling noise caused by fwd flywheel unable to drive cam gear(ref. no. 160) because cam gear will not rotate freely once disengaged bythe slider brake plate (ref. no. 159). the cam gear is kept from rotatingby the shaft on assembly (ref. no. hrpe101).
SONYTCR503
Unit inoperativeUnit inoperative. no power to display nor to drive system.no 5.8 volt supply.
SONYCCDG5
Part number for the cable on the gp-10 gripWe need the part number for the 5-pin male cable that isattached to the gp-10 grip as shown in the diagram. -hq comments: japan informs us that this is not stocked as a repairpart, and as such is unavailable.
SONYCFD64
Distorted cd audio - other audio functions are okDistorted cd audio output other audio functions of unit areok.
SONYSTRAV320
Chattering relay in power supply - unit will not operateChattering ry-901 power supply relay cannot switch on or off -no display.
SONYSLHF450
Intermittent videoIf unit was tapped, the video would cut out but the audio wasnormal. the problem was isolated to the va-14 board. by flexing theboard, the problem could be easily duplicated.
SONYCFS710
Unit eats tapes.Unit eats tapes. i noticed that the washer ref 311 p/n3-701-438-01 does not fit properly on the flywheel (ref312). the washer'sinside diameter is too wide (2.5 mm). consequently, the flywheel does notstay in position and drifts.
SONYMDP700
Part numbers for servo checker cablesThere are no part numbers available for the ld and cd checkercables in the service manuals. -hq comments: part number for the ld cable is j-6080-880-a. part numberfor the cd checker cable is j-6080-922-a. both parts are available in kc.the old servo c
SONYMDP200
Part numbers for servo checker cablesThere are no part numbers for the ld and cd checker cables inthe service manual. -hq comments: part number for the ld cable is j-6080-880-a. part numberfor the cd checker cable is j-6080-922-a. both parts are available in kc.the jigs are no longer nee
SONYKV32XBR15
Intermittent horizontal shift to right, re-soldered ic-582Intermittent picture is shifted to the right - no color anddark. when you turn the set on and off, unit will work ok.
SONYKV2090R
Raster with distorted sound, resolder a-1 connectorDistorted sound, no picture, no snow plain raster only.
SONYCCDV9
Dead unitUnit dead and no display. when lithium battery is taken out,display comes on. when its put back in, the unit dies again.
SONYCDX7580
Illumination weak/won't switch colorsDisplay won't switch color or display is dim.
SONYSLV575UC
Timer record lock upCustomer sets up timer record program 1 to start at (forexample) 8:00 a.m. switch-off at 8:30 a.m. program 2 starts 9:00 a.m.switch-off 9:30 a.m. at 8:00 a.m. unit starts to record, but powerfailure occurs at 8:10 a.m. power returns at 8:40 a.m. cus
SONYCDPC305
Static in output when unit has warmed upStatic in output which increases as the unit (ic) heats up.this is the second encounter of this type in recent weeks.
SONYACV30
Availability of ch boardReference fpr #lo244. the disclaimer no authorizationrequired has not yet been attached to part no. a-4925-307-a in thecomputer so our parts distributors are still rejecting orders for thispart. -hq comments: all semiconductors are now available for the
SONYD4
Defective part - upper lid assemblyWhen replacing upper lid assembly, i found the magnet in thechuck plate assembly on the wrong side. there was no magnetic chucking tospindle motor.
SONYSPP150
No activation during battery saveUnit works in normal mode but will not activate channelscanning in batt save mode.
SONYSPP110
No activation during battery saveUnit works in normal mode but will not activate channelscanning in batt save mode.
SONYSPP300
Handset does not communicate with baseCordless handset had low b+ to pll. only 1.2 volts on q-210collector.