TV Repair: Common Faults and Solutions.
Search:
Results: 87420
Results: 87420
Repair Guide: Common Issues and Fixes
Brand | Model | Fault | Detailed Problem | Solution | By |
---|---|---|---|---|---|
SONY | CCDM8U | Servo circuits dead | Three units with same problem in ssc. you could load tape in and it would thread up but unit would do nothing else after this other than turn on/off. | ||
SONY | STRVX750 | Blowing inverter transistors in pp supply | Set had been blowing out q903/904 every couple of months. | ||
SONY | STRVX5 | Loose radio output | Unit would come on cold and radio functions were fine. afterapprox one hour, unit would loose all sound in radio modes and had nosignal strength indication. display was ok. | ||
SONY | KV20XBR | Pic too white, q803 failure | Original problem was tube had shorted in neck also spark gaphad shorted. after replacing these servicer had picture back but whiteswere to white and gave on defenition. | ||
SONY | KV25XBR | No on-screen display | At turn on set had display, but after a few minutes., display would go out. i had all correct inputs to display ic104 but no output after warm up. | ||
SONY | CCDV8AFU | No chroma record | Unit would record no chroma. playback was ok. | ||
SONY | SPKM8 | Lens cover not available | Rubber lens cover shown to the left of item 9, pg 16 of s/m,does not come with item 9. this piece is also not included with thespk-m8. a customer, however, would like one to protect the lens. -hq comments: i checked with tokyo on this matter. this co | ||
SONY | CFSW360 | Missing part number | Need part number for ac line cord. | ||
SONY | CCDV1 | Pix breaks up | Picture breaks up on monitor. | ||
SONY | CCDM8U | Auto stop | This unit would not stay in the play mode. it would gointo auto stop mode, after a short time. found x681 to be bad. | ||
SONY | D7 | Mistracks | Unit will not play beyond first track of test disc. unit willnot advance tracks at times (intermittent). | ||
SONY | KV25XBR | Flashing in raster | Set would have flashing in raster when it was cold. aboutafter 20 minutes, flashing disappeared. by splaying coolant on componentsproblem was isolated to c1653. | ||
SONY | KV2782R | Shutdown, replace c-681 | Servicer said that b+ was only about 100vdc and if any higher,the set would shut down. by disabling control pin on regulator ic, hecould get b+ up to 135vdc and set would work ok. regulator ic and severalother parts had been replaced. i suggested that | ||
SONY | CDP45 | Intermittent mistracking | Rf waveform was ok except p-p voltage was 2.0v. checkedwaveform from ic201. gain down sw seemed to be on most of time.control signal to switch from ic202 pin 7 was high most of time. flexingckt board caused dc level to drop. | ||
SONY | CCDM8U | Service manual | I do not find an electrical parts list in the manual orsupplements for the above board. -hq comments: because it is so difficult to troubleshoot the mx-2 boarddoes not have a parts listing but is offered as a replacement part p128service manual. | ||
SONY | SLHFT7 | Intermittent no beta hifi pb | Intermittent no beta hi-fi. flexing board would causeproblem to come and go. could not troubleshoot to component level. | ||
SONY | CCDV110 | Bad playback | Poor playback picture. | ||
SONY | CCDV110 | Dead - tape stuck | Found not power up unit. | ||
SONY | SLHFT7 | Lines in picture on some channels | Lines in picture on some channels. | ||
SONY | SL100 | No functions, tape stuck | No functions, pause light on all the time, with power on capsand drum both running. |